MC14067B
Analog Multiplexers /
Demultiplexers
The MC14067 multiplexer/demultiplexer is a digitally controlled
analog switch featuring low ON resistance and very low leakage
current. This device can be used in either digital or analog
applications.
http://onsemi.com
The MC14067 is a 16−channel multiplexer/demultiplexer with an
inhibit and four binary control inputs A, B, C, and D. These control
inputs select 1−of−16 channels by turning ON the appropriate analog
switch (see MC14067 truth table.)
Features
SOIC−24
DW SUFFIX
CASE 751E
• Low OFF Leakage Current
• Matched Channel Resistance
• Low Quiescent Power Consumption
• Low Crosstalk Between Channels
• Wide Operating Voltage Range: 3 to 18 V
• Low Noise
MARKING DIAGRAM
14067B
AWLYYWWG
• Pin for Pin Replacement for CD4067B
• These Devices are Pb−Free and are RoHS Compliant
• NLV Prefix for Automotive and Other Applications Requiring
Unique Site and Control Change Requirements; AEC−Q100
Qualified and PPAP Capable
A
= Assembly Location
WL = Wafer Lot
YY = Year
MAXIMUM RATINGS (Voltages Referenced to V
)
WW = Work Week
SS
G
= Pb−Free Package
Symbol
Parameter
Value
– 0.5 to + 18.0
Unit
V
V
DD
DC Supply Voltage Range
ORDERING INFORMATION
See detailed ordering and shipping information in the package
dimensions section on page 5 of this data sheet.
V , V
in out
Input or Output Voltage Range
(DC or Transient)
– 0.5 to V + 0.5
V
DD
I
in
Input Current (DC or Transient),
per Control Pin
10
mA
I
sw
Switch Through Current
25
mA
P
D
Power Dissipation, per Package
(Note 1)
500
mW
T
Ambient Temperature Range
Storage Temperature Range
– 55 to + 125
– 65 to + 150
260
_C
_C
_C
A
T
stg
T
Lead Temperature
(8–Second Soldering)
L
Stresses exceeding Maximum Ratings may damage the device. Maximum
Ratings are stress ratings only. Functional operation above the Recommended
Operating Conditions is not implied. Extended exposure to stresses above the
Recommended Operating Conditions may affect device reliability.
1. Temperature Derating:
Plastic “P and D/DW” Packages: − 7.0 mW/_C From 65_C To 125_C
This device contains protection circuitry to guard against damage due to high
static voltages or electric fields. However, precautions must be taken to avoid
applications of any voltage higher than maximum rated voltages to this
high−impedance circuit. For proper operation, V and V should be constrained
in
out
to the range V v (V or V ) v V
.
SS
in
out
DD
Unused inputs must always be tied to an appropriate logic voltage level
(e.g., either V or V ). Unused outputs must be left open.
SS
DD
© Semiconductor Components Industries, LLC, 2013
1
Publication Order Number:
May, 2013 − Rev. 8
MC14067B/D