0
PRELIMINARY
CY3650
USB Developer’s Kit
emulated Cypress USB ICs. The development system can be
run in two modes. In the typical development system environ-
ment, the board is controlled through a PC-based interface.
Software running on the PC facilitates debugging through
breakpoints, single stepping, and display and modification of
registers and data RAM. In this mode, firmware can be imple-
mented in on-board EPROM, or downloaded to program RAM.
The RAM option provides a quick and easy method for testing
firmware revisions.
USB Development System on the PC includes:
• USB development board
• Wall transformer power supply (+6V DC, center negative)
• USB cable
• RS-232 serial cable
• 9-pin male to 25-pin female adapter for RS-232 cable
• Registration Card
• USB Development System User’s Guide
• USB Development System Software Guide
• USB Development System Software (3 disks)
• CYASM Assembler software (1 disk)
• Example USB application software included on Assembler
disk
There is also a stand-alone mode which allows portable sys-
tem operation without the PC attached. In this mode, user firm-
ware is programmed in an EPROM, and only power need be
applied to produce a fully operating emulated USB chip.
Additionally, the board may be connected to a logic analyzer
to facilitate full trace capability and complex breakpoints.
Features
• Full development and debug environment for Cypress
Universal Serial Bus Controllers:
— Real-time, full-speed emulation
— Software breakpoints
— Single stepping
— Register, RAM, I/O display/modification
• Debug environment operates without firmware modifi-
cation
• User code can be run from on-board EPROM or RAM
• Stand-alone operation requires only power connection
• Accesstokeymicrocontrollerinternalsignalstoenable
trace and complex breakpoints
USB Development System
• USB Specification Version 1.1 compliant, 1.5 Mbps
speed
• Emulator Board Support for Cypress USB IC family:
• CY3650
RS-232 To
Serial Port
— CY7C63000/1, 20-pin DIP/SOIC, Windowed DIP
— CY7C63100/1, 24-pin SOIC, Windowed DIP
— CY7C63200/1, 18-pin DIP, Windowed DIP
PC
Power
Supply
• CY3651
— CY7C63410/1/2, 40-pin PDIP/48-pin SSOP
Development
Board
— CY7C63413, 40-pin PDIP, 48-pin SSOP, 40-pin Win-
dowed DIP
Logic Analyzer
(Optional)
— CY7C63510/1/2, 48-pin SSOP
— CY7C63513, 48-pin SSOP, 48-pin Windowed DIP
Target System
Introduction
Typical USB Development Environment
The Cypress USB Developer’s Kit is a powerful tool that en-
ables customers to develop USB hardware and firmware with
Cypress Semiconductor Corporation
•
3901 North First Street
•
San Jose
•
CA 95134
•
408-943-2600
Document #: 38-08003 Rev. **
Revised September 21, 2001