MC14001UB, MC14011UB
UB-Suffix Series
CMOS Gates
The UB Series logic gates are constructed with P and N channel
enhancement mode devices in a single monolithic structure
(Complementary MOS). Their primary use is where low power
dissipation and/or high noise immunity is desired. The UB set of
CMOS gates are inverting non−buffered functions.
http://onsemi.com
Features
• Supply Voltage Range = 3.0 Vdc to 18 Vdc
• Linear and Oscillator Applications
SOIC−14
D SUFFIX
CASE 751A
• Capable of Driving Two Low−Power TTL Loads or One
Low−Power Schottky TTL Load Over the Rated Temperature Range
• Double Diode Protection on All Inputs
MARKING DIAGRAM
• Pin−for−Pin Replacements for Corresponding CD4000 Series UB
14
Suffix Devices
140xxUG
AWLYWW
• NLV Prefix for Automotive and Other Applications Requiring
Unique Site and Control Change Requirements; AEC−Q100
Qualified and PPAP Capable
1
• This Device is Pb−Free and is RoHS Compliant
xx
A
WL, L
YY, Y
= Specific Device Code
= Assembly Location
= Wafer Lot
= Year
MAXIMUM RATINGS (Voltages Referenced to V
)
SS
Symbol
Parameter
Value
−0.5 to +18.0
Unit
V
WW, W = Work Week
= Pb−Free Package
V
DD
DC Supply Voltage Range
G
V , V
in out
Input or Output Voltage Range
(DC or Transient)
−0.5 to V + 0.5
V
DD
ORDERING INFORMATION
See detailed ordering and shipping information in the package
dimensions section on page 4 of this data sheet.
I , I
in out
Input or Output Current
(DC or Transient) per Pin
10
mA
P
D
Power Dissipation, per Package
(Note 1)
500
mW
T
Ambient Temperature Range
Storage Temperature Range
−55 to +125
−65 to +150
260
°C
°C
°C
A
T
stg
T
Lead Temperature
L
(8−Second Soldering)
Stresses exceeding those listed in the Maximum Ratings table may damage the
device. If any of these limits are exceeded, device functionality should not be
assumed, damage may occur and reliability may be affected.
1. Temperature Derating: “D/DW” Package: –7.0 mW/_C From 65_C To 125_C
This device contains protection circuitry to guard against damage due to high
static voltages or electric fields. However, precautions must be taken to avoid
applications of any voltage higher than maximum rated voltages to this
high−impedance circuit. For proper operation, V and V should be constrained
in
out
to the range V ≤ (V or V ) ≤ V .
SS
in
out
DD
Unused inputs must always be tied to an appropriate logic voltage level
(e.g., either V or V ). Unused outputs must be left open.
SS
DD
© Semiconductor Components Industries, LLC, 2014
1
Publication Order Number:
July, 2014 − Rev. 10
MC14001UB/D