MURF3020PTD thru MURF3060PTD
Pb
MURF3020PTD thru MURF3060PTD
Pb Free Plating Product
30.0 Ampere Insulated Dual Doubler Ultra Fast Recovery Rectifier Diodes
Unit: inch (mm)
TO-3P(H)IS
Features
.217 (5.5)
.130 (3.3)
.610 (15.5)
ꢀDual rectifier construction, positive center-tap
ꢀPlastic package has Underwriters Laboratory
Flammability Classification 94V0
.177
(4.5)
.378
(9.6)
ꢀGlass passivated chip junctions
ꢀSuperfast recovery time, high voltage
ꢀLow forward voltage, high current capability
ꢀLow thermal resistance
.965
(24.5)
ꢀLow power loss, high efficiency
.177
(4.5)
ꢀHigh temperature soldering guaranteed:
o
260 C, 0.16”(4.06mm)from case for 10 seconds
.720
(18.3)
Min
Mechanical Data
Cases: Insulated/Isolated TO-3P(H)IS
ꢀ
.215 (5.47)
.138 (3.5)
ꢀTerminals: Pure tin plated, lead free solderable per
MIL-STD-750. Method 2026
ꢀPolarity: As marked
ꢀMounting position: Any
Positive
Common Cathode
Suffix "PT"
ꢀMounting torque: 10in-lbs. Max.
ꢀWeight: 0.2 ounce, 5.6 gram approximately
Negative
Common Anode
Suffix "PTA"
Doubler
Tandem Polarity
Suffix "PTD"
MAXIMUM RATINGS AND ELECTRICAL CHARACTERISTICS
o
Rating at 25
C ambient temperature unless otherwise specified.
Single phase, half wave, 60Hz, resistive or inductive load.
For capacitive load, derate current by 20%.
MURF3020PT MURF3040PT MURF3060PT
MURF3020PTA MURF3040PTA MURF3060PTA
MURF3020PTD MURF3040PTD MURF3060PTD
UNIT
SYMBOL
V
V
V
Maximum Recurrent Peak Reverse Voltage
Maximum RMS Voltage
VRRM
VRMS
VDC
200
140
200
400
280
400
600
420
600
Maximum DC Blocking Voltage
Maximum Average Forward Rectified
Current TC=125oC
30.0
300
1.3
A
A
V
IF(AV)
Peak Forward Surge Current, 8.3ms single
Half sine-wave superimposed on rated load
(JEDEC method)
IFSM
Maximum Instantaneous Forward Voltage
@ 15.0 A
VF
IR
0.98
1.7
Maximum DC Reverse Current @TJ=25oC
At Rated DC Blocking Voltage @TJ=125oC
uA
uA
nS
10
500
Maximum Reverse Recovery Time (Note 1)
Typical junction Capacitance (Note 2)
Trr
CJ
35
pF
oC
150
Operating Junction and Storage
Temperature Range
T
J, TSTG
-55 to +150
.
NOTES : (1) Reverse recovery test conditions I
(2) Thermal Resistance junction to terminal.
(3) Measured at 1.0 MHz and applied reverse voltage of 4.0 Volts DC.
F
= 0.5A I
R
= 1 0A Irr = 0.25A.
Rev.04
© 2006 Thinki Semiconductor Co.,Ltd.
Page 1/2
http://www.thinkisemi.com/