Datasheet > AN1013

AN1013

更新时间： 2024-10-28 03:18:47

阅读下载

中文翻译

获取价格

如果您发现信息不准确，欢迎纠错

AN1013 数据手册

AN1013

APPLICATION NOTE

MONO CLASS_D AMPLIFIERS

by M. Masini, L. Pagotto

INTRODUCTION

The TDA7480/81/82 are single ended , split supply, class_D amplifiers. The output of the amplifier is a

high frequency square wave (around 100Khz), rail to rail, with variable duty cycle.

The audio information is the average value of the output square wave.

To obtain the audio signal, the output must be low pass filtered.

The main issue of this amplifier is the very low dissipated power (the very high efficiency) compared to a

normal class AB amplifier.

The preamplifier provides the voltage gain of the overall amplifier. The second stage is the power stage,

with a gain 1.5, that is the high efficiency class_D amplifier.

The class_D amplifier stage is done with a multivibrator : with no signal it generates a 50% duty cycle

square wave, with signal applied, it changes the duty cycle.

The switching frequency is set by the voltage on pin 9 (DIP20) or pin 6 (MW15).

The output power stage is done with N-ch DMOS power with the upper one supplied by a bootstrap ca-

pacitor (C11 in the application circuit).

1. CRITICAL COMPONENTS IN THE APPLICATION

A: Bypass high frequency filtering capacitor on supply

The most important filter capacitor is C5 (see application circuit) between pin 13/14 for MW15 package

or pin 16/17 for DIP20 package.

The value of the parasitic inductance between this capacitance and the IC pins is related to the ampli-

tude of the spikes on the power supply pins at every commutations of the output.

In fact, for any commutation, there is an abrupt variation of the current in the parasitic inductances Lpar

in series to the supply. This abrupt variation increases as the output current increases and can be typi-

cally of some amperes on 10ns. With this slew rate of the current, also an inductance of about some the

of nH (i.e. the lead inductance of the pin) generatesvoltage spikes of some volts.

Figure 1. Block Diagram

February 1998

1/13

12 3 4 5 6 7...13

中文翻译

下载PDF

型号	品牌	获取价格	描述	数据表
AN1014	GSI	获取价格	tKCvar Specification
AN-1014	CYMBET	获取价格	Using the AtmelÂ® picoPower AVR Microcontroll
AN10145	NXP	获取价格	Bi-directional low voltage translators
AN1016	GSI	获取价格	SigmaCIO DDR-IIIe DQ ODT Control
AN1016/D	ETC	获取价格	Infrared Sensing and Data Transmission Fundamentals
AN1017	GSI	获取价格	SigmaQuad-IIIe Input and Output Clocking Scheme
AN1018	MICROCHIP	获取价格	A broad portfolio of high performance, best-in-class Serial Memory Products to meet all yo
AN1019	GSI	获取价格	SigmaQuad-II+ and SigmaDDR-II+ On-Die Termination (ODT)
AN1020	MICROCHIP	获取价格	A broad portfolio of high performance, best-in-class Serial Memory Products to meet all yo
AN1020	GSI	获取价格	Interfacing GSI Sync SRAMs to a Freescale Mutiplexed MPC567xF or PXR40xx Microcontroller