June 2005
DS90CR481 / DS90CR482
48-Bit LVDS Channel Link SER/DES − 65 - 112 MHz
enhancement. To increase bandwidth, the maximum clock
rate is increased to 112 MHz and 8 serialized LVDS outputs
are provided. Cable drive is enhanced with a user selectable
pre-emphasis feature that provides additional output current
during transitions to counteract cable loading effects. Op-
tional DC balancing on a cycle-to-cycle basis, is also pro-
vided to reduce ISI (Inter-Symbol Interference). With pre-
emphasis and DC balancing, a low distortion eye-pattern is
provided at the receiver end of the cable. A cable deskew
capability has been added to deskew long cables of pair-to-
pair skew of up to +/−1 LVDS data bit time (up to 80 MHz
Clock Rate). These three enhancements allow cables 5+
meters in length to be driven.
General Description
The DS90CR481 transmitter converts 48 bits of CMOS/TTL
data into eight LVDS (Low Voltage Differential Signaling)
data streams. A phase-locked transmit clock is transmitted in
parallel with the data streams over a ninth LVDS link. Every
cycle of the transmit clock 48 bits of input data are sampled
and transmitted. The DS90CR482 receiver converts the
LVDS data streams back into 48 bits of LVCMOS/TTL data.
At a transmit clock frequency of 112MHz, 48 bits of TTL data
are transmitted at a rate of 672Mbps per LVDS data channel.
Using a 112MHz clock, the data throughput is 5.38Gbit/s
(672Mbytes/s). At a transmit clock frequency of 112MHz, 48
bits of TTL data are transmitted at a rate of 672Mbps per
LVDS data channel. Using a 66MHz clock, the data through-
put is 3.168Gbit/s (396Mbytes/s).
The chipset is an ideal means to solve EMI and cable size
problems associated with wide, high speed TTL interfaces.
The multiplexing of data lines provides a substantial cable
reduction. Long distance parallel single-ended buses typi-
cally require a ground wire per active signal (and have very
limited noise rejection capability). Thus, for a 48-bit wide
data and one clock, up to 98 conductors are required. With
this Channel Link chipset as few as 19 conductors (8 data
pairs, 1 clock pair and a minimum of one ground) are
needed. This provides an 80% reduction in cable width,
which provides a system cost savings, reduces connector
physical size and cost, and reduces shielding requirements
due to the cables’ smaller form factor.
Features
n 3.168 Gbits/sec bandwidth with 66 MHz Clock
n 5.376 Gbits/sec bandwidth with 112 MHz Clock
n 65 - 112 MHz input clock support
n LVDS SER/DES reduces cable and connector size
n Pre-emphasis reduces cable loading effects
n Optional DC balance encoding reduces ISI distortion
n Cable Deskew of +/−1 LVDS data bit time (up to 80
MHz Clock Rate)
n 5V Tolerant TxIN and control input pins
n Flow through pinout for easy PCB design
n +3.3V supply voltage
The 48 CMOS/TTL inputs can support a variety of signal
combinations. For example, 6 8-bit words or 5 9-bit (byte +
parity) and 3 controls.
n Transmitter rejects cycle-to-cycle jitter
n Conforms to ANSI/TIA/EIA-644-1995 LVDS Standard
The DS90CR481/DS90CR482 chipset is improved over prior
generations of Channel Link devices and offers higher band-
width support and longer cable drive with three areas of
Generalized Block Diagrams (DS90CR481 and DS90CR482)
20009101
© 2005 National Semiconductor Corporation
DS200091
www.national.com