19-5586; Rev 10/10
DS1350W
3.3V 4096k Nonvolatile SRAM
with Battery Monitor
www.maxim-ic.com
FEATURES
. 10 years minimum data retention in the
absence of external power
PIN ASSIGNMENT
. Data is automatically protected during power
loss
. Power supply monitor resets processor when
BW
A15
A16
RST
VCC
WE
OE
CE
DQ7
DQ6
DQ5
DQ4
DQ3
DQ2
DQ1
DQ0
GND
A18
A17
A14
A13
A12
A11
A10
A9
A8
A7
A6
A5
1
2
3
4
5
6
7
8
34
33
32
31
30
29
28
27
26
25
24
23
22
21
20
19
18
VCC power loss occurs and holds processor in
reset during VCC ramp-up
9
. Battery monitor checks remaining capacity
daily
10
11
12
13
14
15
16
17
. Read and write access times of 100ns
. Unlimited write cycle endurance
. Typical standby current 50 µA
. Upgrade for 512k x 8 SRAM, EEPROM or
Flash
. Lithium battery is electrically disconnected to
retain freshness until power is applied for the
first time
. Optional industrial temperature range of
-40°C to +85°C, designated IND
. PowerCap Module (PCM) package
- Directly surface-mountable module
- Replaceable snap-on PowerCap provides
lithium backup battery
A4
A3
A2
A1
VBAT
GND
A0
34-Pin PowerCap Module (PCM)
(Uses DS9034PC+ or DS9034PCI+ PowerCap)
PIN DESCRIPTION
A0-A18
DQ0-DQ7
CE
- Address Inputs
- Data In/Data Out
- Chip Enable
- Write Enable
- Output Enable
- Reset Output
WE
OE
RST
BW
VCC
GND
NC
- Standardized pinout for all nonvolatile
SRAM products
- Detachment feature on PowerCap allows
easy removal using a regular screwdriver
- Battery Warning Output
- Power (+3.3 Volts)
- Ground
- No Connect
DESCRIPTION
The DS1350W 3.3V 4096k Nonvolatile SRAM is a 4,194,304-bit, fully static, nonvolatile SRAM
organized as 524,288 words by eight bits. Each NV SRAM has a self-contained lithium energy source
and control circuitry which constantly monitors VCC for an out-of-tolerance condition. When such a
condition occurs, the lithium energy source is automatically switched on and write protection is
unconditionally enabled to prevent data corruption. Additionally, the DS1350W has dedicated circuitry
for monitoring the status of VCC and the status of the internal lithium battery. DS1350W devices in the
PowerCap Module package are directly surface mountable and are normally paired with a DS9034PC
PowerCap to form a complete Nonvolatile SRAM module. The devices can be used in place of 512k x 8
SRAM, EEPROM or Flash components.
1 of 10