CY62167DV30
MoBL
16-Mbit (1M x 16) Static RAM
reduces power consumption by 99% when addresses are not
toggling. The device can also be put into standby mode when
deselected (CE1 HIGH or CE2 LOW or both BHE and BLE are
HIGH). The input/output pins (I/O0 through I/O15) are placed
in a high-impedance state when: deselected (CE1HIGH or CE2
LOW), outputs are disabled (OE HIGH), both Byte High
Enable and Byte Low Enable are disabled (BHE, BLE HIGH),
or during a Write operation (CE1 LOW, CE2 HIGH and WE
LOW).
Writing to the device is accomplished by taking Chip Enables
(CE1 LOW and CE2 HIGH) and Write Enable (WE) input LOW.
If Byte Low Enable (BLE) is LOW, then data from I/O pins (I/O0
through I/O7), is written into the location specified on the
address pins (A0 through A19). If Byte High Enable (BHE) is
LOW, then data from I/O pins (I/O8 through I/O15) is written into
the location specified on the address pins (A0 through A19).
Features
• Very high speed: 55 ns
• Wide voltage range: 2.20V – 3.60V
• Ultra-low active power
— Typical active current: 2 mA @ f = 1 MHz
— Typical active current: 15 mA @ f = fmax
• Ultra-low standby power
• Easy memory expansion with CE1, CE2, and OE
features
• Automatic power-down when deselected
• CMOS for optimum speed/power
• Packages offered in a 48-ball BGA and 48-pin TSOPI
Reading from the device is accomplished by taking Chip
Enables (CE1 LOW and CE2 HIGH) and Output Enable (OE)
LOW while forcing the Write Enable (WE) HIGH. If Byte Low
Enable (BLE) is LOW, then data from the memory location
specified by the address pins will appear on I/O0 to I/O7. If Byte
High Enable (BHE) is LOW, then data from memory will appear
on I/O8 to I/O15. See the truth table at the back of this data
sheet for a complete description of Read and Write modes.
Functional Description[1]
The CY62167DV30 is a high-performance CMOS static RAM
organized as 1M words by 16 bits. This device features
advanced circuit design to provide ultra-low active current.
This is ideal for providing More Battery Life (MoBL) in
portable applications such as cellular telephones. The device
also has an automatic power-down feature that significantly
Logic Block Diagram
DATA IN DRIVERS
A10
A 9
A 8
A 7
A 6
A 5
A 4
A 3
1M × 16
RAM Array
I/O0 – I/O7
I/O8 – I/O15
A 2
A 1
A 0
COLUMN DECODER
BHE
WE
CE2
CE
1
OE
BLE
Power-down
Circuit
CE2
BHE
BLE
CE
1
Note:
1. For best-practice recommendations, please refer to the Cypress application note “System Design Guidelines” on http://www.cypress.com.
Cypress Semiconductor Corporation
•
3901 North First Street
•
San Jose, CA 95134
•
408-943-2600
Document #: 38-05328 Rev. *E
Revised June 21, 2004