UNR D5/D12 Series
Single Output, Non-Isolated, 5 or 12VIN to 1.8/2.5/3.3VOUT
8 and 10 Amp DC/DC Converters
www.murata-ps.com
OBSOLETE PRODUCT
As supply voltages trend lower and load currents increase, centralized power
becomes more imLpraacstitcatl.iTmheetigbhtuaycc:u3racMy, laowrcnohise2a0n1d 4quick transient
Features
Input ranges of 4.75-5.5V or 10.8-13.6V
Output voltages of 1.8/2.5/3.3V
response demanded by today's low voltage CPU's, ASIC's and DSP's make power
processing at thCe pliocinkt ohf ueserethefoonrlymviaboleresoliuntiofno. Trhme UaNtRio18n-3.3W series pro-
vides a complete line of non-isolated DC/DC converters to satisfy this requirement.
With input voltages of 5V (-D5 models) and 12V (-D12 models) these converters
offer standard output voltages of 1.8, 2.5 and 3.3 Volts and up to 10 Amps of output
current in both through-hole and surface-mount 1" x 2" metal cases.
With on/off control and output voltage trim capability as standard features, these
non-isolated converters exploit full synchronous rectification, planar magnetics, and
100% automated assembly to deliver high efficiencies (to 91%) and low noise at low
cost.
8 and 10 Amp output current models
VOUT user-trimmable from 1.28V to 3.6V
Non-isolated, full synchronous topology
1" x 2" through-hole or SMT package
Gull-wing leads for SMT package
High efficiency to 91%; Low noise
200kHz switching; Planar magnetics
These versatile DC/DC’s are fully line and load regulated. They feature quick
transient response (50µsec), user-optional on/off control (for power sequencing),
and output overcurrent detection and shutdown ("hiccup" technique with auto-recov-
ery). Their impressive guaranteed efficiencies enable them to deliver fully rated
output power from –40 to +50/55°C (ambient) without supplemental cooling.
If your high current requirements have made the use of inefficient linear regula-
tors impractical, take a look at one of Murata Power Solutions’ new switching buck
regulators. Their high efficiency, ease-of-use, long-term reliability, and overall cost
effectiveness will impress you. Safety agency approvals and EMC characterizations
are currently in progress.
–40 to +40/50/60°C ambient operation with
no derating
Remote on/off control; Output overcurrent
detection
IEC950/EN60950/UL1950 approval
+VIN
+VOUT
INPUT
RETURN
OUTPUT
RETURN
LOGIC
GROUND
VOLTAGE
BOOST
➀
OVERCURRENT
DETECTION
+VCC
ON/OFF
CONTROL
PWM
CONTROLLER
REFERENCE &
ERROR AMP
VOUT
TRIM
➀ -D5 models only.
Figure 1. Simplified Schematic
Typical topology is shown.
For full details go to
www.murata-ps.com/rohs
www.murata-ps.com/support
UNR18-33W.C01 Page 1 of 9