®
IS25C01
1K-BIT SPI SERIAL
ISSI
PreliminaryInformation
January2006
ELECTRICALLY ERASABLE PROM
FEATURES
• SerialPeripheralInterface(SPI)Compatible
— Supports SPI Modes 0 (0,0) and 3 (1,1)
• Low-voltageOperation
— Vcc = 1.8V to 5.5V
• LowpowerCMOS
— Active current less than 3.0 mA (2.5V)
— Standby current less than 1 µA (2.5V)
• Block Write Protection
DESCRIPTION
The IS25C01 is an electrically erasable PROM device
that uses the Serial Peripheral Interface (SPI) for
communications. The IS25C01 is 1Kbit
(128 x 8). The IS25C01 EEPROM is offered in a wide
operating voltage range of 1.8V to 5.5V to be compatible
with most application voltages. ISSI designed the
IS25C01 to be an efficient SPI EEPROM solution. The
device is packaged in 8-pin PDIP, 8-pin SOIC, and 8-pin
TSSOP.
— Protect 1/4, 1/2, or Entire Array
•
8bytepagewritemode
— Partial page writes allowed
The functional features of the IS25C01 allow it to be
amongthemostversatileserialnon-volatilememories
available. Each device has a Chip-Select (CS) pin, and
a 3-wire interface of Serial Data In (SI), Serial Data Out
(SO), and Serial Clock (SCK). While the 3-wire inter-
face of the IS25C01 provides for high-speed access, a
HOLD pin allows the memories to ignore the interface in
a suspended state; later the HOLD pin re-activates
communication without re-initializing the serial se-
quence. A Status Register facilitates a flexible write
• 10 MHz Clock Rate (5V)
• Self timed write cycles
— 5 ms max. @ 2.5V
• High-reliability
— Endurance: 1 million cycles per byte
— Data retention: 100 years
• 8-pin PDIP, 8-pin SOIC, and 8-pin TSSOP packages
areavailable
• Lead-freeavailable
protection mechanism, and a device-ready bit (RDY).
Copyright © 2006 Integrated Silicon Solution, Inc. All rights reserved. ISSI reserves the right to make changes to this specification and its products at any time
without notice. ISSI assumes no liability arising out of the application or use of any information, products or services described herein. Customers are advised to
obtain the latest version of this device specification before relying on any published information and before placing orders for products.
Integrated Silicon Solution, Inc. — 1-800-379-4774
1
Preliminary Information Rev. 00B
12/23/05