5秒后页面跳转
捷配首页

Datasheet > 微控制器和处理器 > 总线控制器> PEX8111-BB66BCF
PEX8111-BB66BCF PDF预览

PEX8111-BB66BCF

更新时间： 2024-09-19 06:00:15
品牌 Logo 应用领域
PLX 总线控制器微控制器和处理器外围集成电路PC时钟
页数 文件大小 规格书
2页 116K
描述
PCI Express to PCI Bridge

阅读下载

中文翻译

获取价格

PEX8111-BB66BCF 技术参数

是否无铅：不含铅是否Rohs认证：符合
生命周期：Obsolete零件包装代码：BGA
包装说明：BGA,针数：144
Reach Compliance Code：unknownECCN代码：3A001.A.3
HTS代码：8542.31.00.01风险等级：5.79
Is Samacsys：N其他特性：ALSO REQUIRES AT 3.3V SUPPLY
地址总线宽度：32最大时钟频率：66 MHz
外部数据总线宽度：32JESD-30 代码：S-PBGA-B144
长度：13 mm端子数量：144
最高工作温度：70 °C最低工作温度：
封装主体材料：PLASTIC/EPOXY封装代码：BGA
封装形状：SQUARE封装形式：GRID ARRAY
峰值回流温度（摄氏度）：NOT SPECIFIED认证状态：Not Qualified
座面最大高度：2.03 mm最大供电电压：1.6 V
最小供电电压：1.4 V标称供电电压：1.5 V
表面贴装：YES技术：CMOS
温度等级：COMMERCIAL端子形式：BALL
端子节距：1 mm端子位置：BOTTOM
处于峰值回流温度下的最长时间：NOT SPECIFIED宽度：13 mm
uPs/uCs/外围集成电路类型：BUS CONTROLLER, PCIBase Number Matches：1

PEX8111-BB66BCF 数据手册

 浏览型号PEX8111-BB66BCF的Datasheet PDF文件第2页 
Version 1.4 2005  
PEX 8111  
Features  
ƒ General Features  
o Forward and Reverse bridging  
o144-ball BGA package with standard  
1.0 mm pitch (13mm x 13mm)  
oAlternative fine-pitch BGA package  
(10mm x 10mm)  
ExpressLane™ PCI Express to PCI Bridge  
Reversible Bridge in a Tiny Package  
o Low power – 400 milliwatts  
oEEPROM configuration option with  
SPI  
o Internal 8Kbyte shared RAM  
o 1.5 V core supply voltage  
o JTAG  
The PLX Technology PEX 8111 bridge enables designers to migrate legacy PCI bus  
interfaces to the new advanced serial PCI Express. This is ideal for including  
existing PCI ICs on a PCI Express™ Adapter Board, such as the new ExpressCard™  
or AdvancedMC™ standards. Both the standard BGA package and the tiny 10mm x  
10mm fine-pitch package offering make the PEX 8111 bridge well suited for  
applications where board real estate is at a premium. With its low power 0.15 micron  
CMOS design, the PEX 8111 consumes only about 400 mW of power.  
o Four (4) GPIO pins for maximum  
design flexibility  
o Extensive PME support including  
D0 and D0Active, D1, D2 and D3Hot  
and D3Cold  
Forward and Reverse Bridging  
The PEX 8111 supports forward and reverse bridging as defined by the  
PCI Express-to-PCI/PCI-X Bridge Specification 1.0. In forward mode, the bridge  
allows legacy PCI chips and adapters to be used with new PCI Express processor  
systems. Reverse bridge operation allows conventional PCI processors and chipsets  
to configure and control advanced PCI Express switches and endpoints. The reverse  
PEX 8111 not only allows complete configuration of a downstream PCI Express  
system from the PCI bus, but it also handles limited PCI Express root functions for  
reverse interrupt and Power Management Events.  
o Lead-free packaging available  
ƒ Integrated PCI Express Interface  
o PCI Express Base 1.0a compliant  
o x1 Link, dual-simplex, 2.5 Gbps per  
direction  
o One virtual channel  
o Automatic LVDS polarity reversal  
o 128 byte maximum payload size  
o Link CRC  
o Link power management  
o Flow control buffering  
PCI Bus (32-bit, 33/66 MHz)  
Block Diagram  
The PEX 8111 is equipped with a  
standard PCI Express port that  
operates as a single, x1 link with a  
maximum of 250 Megabytes per  
o PCI Express transaction queues for  
eight (8) outstanding TLPs  
ƒ PCI Interface  
second of throughput per transmit  
PCI Master and Target Interface Logic  
o PCI v.3.0: 32 bits, up to 66 MHz  
o PCI Power Management 1.1  
o Internal arbiter supports up to 4  
external masters; REQ#/GNT#  
signals  
and receive direction. The single 2.5  
Gbps integrated SerDes delivers the  
highest bandwidth with the lowest  
possible pin count using LVDS  
technology.  
Configuration  
Registers  
8K Shared  
RAM  
FIFOs  
o 3.3V I/O and 5V tolerant PCI  
o Message Signal Interrupt (MSI)  
support  
o Provides PCI clock output  
o Four mailbox registers for messaging  
o VGA and ISA Enable registers for  
legacy operation  
PCI Express Transaction Layer  
(Packet Construction Logic)  
The PEX 8111 has a single parallel  
bus segment supporting the PCI v.3.0  
protocol, and a 32-bit wide parallel  
data path running up to 66MHz.  
PCI Express Data Link Layer  
PCI Express PHY Layer  
The device supports internal queues  
with flow control features to optimize  
throughput and traffic flow.  
j
PCI Express Link (1 lane, 2.5 GHz)  
Figure 1. PEX 8111 Block Diagram  
12

中文翻译

下载PDF

与PEX8111-BB66BCF相关器件

型号 品牌 获取价格 描述 数据表
PEX8111-BB66FBC PLX

获取价格

 		PCI Express to PCI Bridge
PEX8111-BB66FBCF PLX

获取价格

 		PCI Express to PCI Bridge
PEX8111RDK-F PLX

获取价格

 		PCI Express to PCI Bridge
PEX8111RDK-R PLX

获取价格

 		PCI Express to PCI Bridge
PEX8112 PLX

获取价格

 		ExpressLane™ PCI Express to PCI Bridge
PEX8112-AA66BI PLX

获取价格

 		Bus Controller, CMOS, PBGA144
PEX8112-AA66BIF PLX

获取价格

 		ExpressLane™ PCI Express to PCI Bridge
PEX8112-AA66FBIF PLX

获取价格

 		ExpressLane™ PCI Express to PCI Bridge
PEX8112RDK-F PLX

获取价格

 		ExpressLane™ PCI Express to PCI Bridge
PEX8112RDK-R PLX

获取价格

 		ExpressLane™ PCI Express to PCI Bridge

与PEX8111-BB66BCF相关文章

您还可以找


热门产品
PCB打样/小批量
铝基板
BOM智能配单
PCBA制造
钣金
精密CNC
模具注塑
薄膜开关
精选活动
PCBA打样特惠
四六层板品质升级
铝基板品质升级
一体化电子制造
DFM下载
服务支持
企业认证
产品展示
工厂展示
工艺能力
积分商城
关于捷配
捷配简介
企业文化
公司动态
人才招聘
联系我们
帮助中心
下单流程
付款流程
开票流程
常见问题
全球PCB制造服务专线 400-613-0088

工作时间：9:00-21:00

CEO邮箱：ceo@jiepei.com

投诉邮箱：tousu@jiepei.com

捷配网-微信公众号 微信公众号
捷配网-微信公众号 抖音公众号
资质认证：
合作快递：
支付方式：
Copyright © 2024 Jiepei.com Inc. All Rights Reserved. 版权所有:杭州捷配信息科技有限公司 浙公网安备 33010502006866号 浙ICP备10014259号-119 营业执照ICP证