Order this document
by MCM69F817/D
SEMICONDUCTOR TECHNICAL DATA
MCM69F817
Product Preview
256K x 18 Bit Flow–Through
BurstRAM Synchronous
Fast Static RAM
The MCM69F817 is a 4M bit synchronous fast static RAM designed to provide
a burstable, high performance, secondary cache for the PowerPC and other
high performance microprocessors. It is organized as 256K words of 18 bits
each. This device integrates input registers, a 2–bit address counter, and high
speed SRAM onto a single monolithic circuit for reduced parts count in cache
dataRAMapplications. Synchronousdesignallowsprecisecyclecontrolwiththe
use of an external clock (K).
ZP PACKAGE
PBGA
CASE 999–01
Addresses (SA), data inputs (DQx), and all control signals except output
enable(G) and linear burst order (LBO) are clock (K) controlled through positive–
edge–triggered noninverting registers.
Bursts can be initiated with either ADSP or ADSC input pins. Subsequent burst
addresses can be generated internally by the MCM69F817 (burst sequence
operates in linear or interleaved mode dependent upon the state of LBO) and
controlled by the burst address advance (ADV) input pin.
Write cycles are internally self–timed and are initiated by the rising edge of the
clock (K) input. This feature eliminates complex off–chip write pulse generation
and provides increased timing flexibility for incoming signals.
Synchronous byte write (SBx), synchronous global write (SGW), and synchro-
nous write enable (SW) are provided to allow writes to either individual bytes or
to all bytes. The two bytes are designated as “a” and “b”. SBa controls DQa and
SBb controls DQb. Individual bytes are written if the selected byte writes SBx are
asserted with SW. All bytes are written if either SGW is asserted or if all SBx and
SW are asserted.
For read cycles, a flow–through SRAM allows output data to simply flow freely
from the memory array.
The MCM69F817 operates from a 3.3 V core power supply and all outputs
operate on a 3.3 V or 2.5 V power supply. All inputs and outputs are JEDEC stan-
dard JESD8–5 compatible.
•
MCM69F817 Speed Options
Flow–Through
t
Speed
t
Setup
0.5 ns
0.5 ns
0.5 ns
Hold
1 ns
1 ns
1 ns
I
DD
KHQV
KHKH
150 MHz
133 MHz
117 MHz
6.7 ns
7.5 ns
8.5 ns
6 ns
375 mA
350 mA
325 mA
6.5 ns
7 ns
•
3.3 V + 10%, – 5% Core Power Supply, Operates with a 3.3 V or 2.5 V I/O
Supply
•
•
•
•
•
•
•
ADSP, ADSC, and ADV Burst Control Pins
Selectable Burst Sequencing Order (Linear/Interleaved)
Single–Cycle Deselect Timing
Internally Self–Timed Write Cycle
Byte Write and Global Write Control
PB1 Version 2.0 Compatible
JEDEC Standard 119–Pin PBGA Package
BurstRAM is a trademark of Motorola, Inc.
The PowerPC name is a trademark of IBM Corp., used under license therefrom.
This document contains information on a new product under development. Motorola reserves the right to change or discontinue this product without notice.
REV 1
6/26/97
Motorola, Inc. 1997
MOTOROLA FAST SRAM
MCM69F817
1