Advance Information
This document contains information on a product under development. The parametric information
contains target parameters that are subject to change.
CN8380
Quad T1/E1 Line Interface
The CN8380 is a fully integrated quad line interface unit for both 1.544 Mbps (T1) and
2.048 Mbps (E1) applications. It is designed to complement T1/E1 framers or operate as
a stand-alone line interface to synchronous or plesiochronous mappers and
multiplexers. The device can be controlled through a host mode serial port or by
hardware mode operation, where device control and status are obtained through
non-multiplexed dedicated pins. Many of these pins are also dedicated to individual
channels for maximum flexibility and for use in redundant systems. Integrated in the
CN8380 device is a clock rate adapter (CLAD), which provides various low-jitter
programmable system clock outputs. The receive section of the CN8380 is designed to
recover encoded signals from lines having up to 12 dB of attenuation. The transmit
section consists of a programmable, precision pulse shaper.
Distinguishing Features
•
Four T1/E1 short haul line interfaces
in a single chip
•
•
On-chip CLAD /system synchronizer
Digital (crystal-less) jitter attenuators
selectable for transmitter/receiver on
each line interface
•
•
Meets AT&T pub 62411 jitter specs
Meets ITU G.703, ETS 300 011
(PSTNX) Connections
•
•
AMI/B8ZS/HDB3 line codes
Host serial port or hardware only
control modes
•
•
On-chip receive clock recovery
Common transformers for 120/75 Ω
E1 and 100 Ω T1
•
•
•
Low-power 3.3 V power supply
Transmitter performance monitor
Compatible with latest ANSI, ITU-T,
and ETSI standards
Functional Block Diagram
•
•
128-pin MQFP package
Remote and local loopbacks
Clock
and
Data
RPOSO[1]
RTIP[1]
Re-
ceiver
ZCS
Decode
RLOS
Detect
RNEGO[1]
RCKO[1]
RRING[1]
Recovery
Applications
Jitter
Attenuator
•
•
•
•
SONET/SDH multiplexers
T3 and E3/E4 (PDH) multiplexers
ATM multiplexers
Voice compression and voice
processing equipment
WAN routers and bridges
Digital loop carrier terminals (DLC)
HDSL terminal units
TPOSI[1]
TNEGI[1]
TCLK[1]
XTIP[1]
Pulse
Shaping
ZCS
Decode
Driver
TAIS
XRING[1]
LIU #1
LIU #2
LIU #3
LIU #4
•
•
•
•
•
•
•
•
Remote concentrators
JTAG
Test Port
Clock Rate Adapter
Control
47
Central office equipment
PBXs and rural switches
PCM/voice channel banks
Digital access and cross-connect
systems (DACS)
4
5
JTAG
Test
Signals
Control and Host
Alarm Signals Serial
10 MHz Variable 1.544 2.048 32.768 8 kHz–32 MHz
Fixed Reference MHz MHz MHz Selectable
Port Reference
8380_001
Data Sheet
Advance Information
N8380DSA
April 26, 1999