Datasheet
Automotive IPS series
1ch High-side switch
BD1Hx500 Series BD1HxU50 Series
Features
Product Summary
Operating voltage
■ Built-in overcurrent protection circuit
■ Built-in Thermal Shut Down(TSD)
■ Built-in Open Load Detection circuit(When Output is
OFF)
■ Possibility to control directly from CMOS logic IC
■ Low standby current
■ Built-in Under Voltage Lock Out circuit
■ Built-in diagnostic(ST) output function
■ Low On resistance of RDS(ON)=500mΩ(Typ) (VDD=12V,
Ta=25°C, Io=0.25A)
4V to 18V
On-state resistance
(25°C, Typ)
Overcurrent limit (Typ)
500mΩ
1.45A
33mJ
Active clamp energy (25°C)
Package
HTSOP-J8
■ Monolithic power IC that has a built in control part
(CMOS) and a power MOS FET on 1chip
■ 1ch High-side switch for the mechanical relay coil
drive
4.90mm x 6.00mm x 1.00mm
2.90mm x 3.00mm x 0.60mm
2.90mm x 4.00mm x 0.90mm
HSON8
MSOP8
■ AEC-Q100 qualified (1)
(1) Grade 1
General Description
BD1Hx500 Series BD1HxU50 Series are an Automotive
1ch High-Side switch.
It has a built-in overcurrent protection circuit, Thermal
Shut Down (TSD) circuit, Open Load Detection circuit,
Under Voltage Lock Out circuit, and has diagnostic (ST)
output function at the time during abnormal detection.
HSON 8
HTSOP-J8
MSOP 8
Application
■ For automotive (Air conditioner, body equipment, and
meter, etc.)
Typical Application Circuit
5V
The diode for a battery
reverse set.
20kΩ to 47kΩ
ST
1μF
VBAT
12V
8
7
6
5
GND
ST
N.C
VDD
VDD
VDD
BG
UVLO
Charge
pump
Vref
(1.2MHz(Typ))
Current
limitation
Temperature
sencor
Logic
IN
GND
2
OUT
OUT
1
3
4
Input
load
PGND
○Product structure:Silicon monolithic integrated circuit ○This product is not designed protection against radioactive rays
www.rohm.com
TSZ02201-0G3G0BD00070-1-2
2022.05.10 Rev.004
© 2015 ROHM Co., Ltd. All rights reserved.
1/18
TSZ22111・14・001