5秒后页面跳转
AT29LV040A PDF预览

AT29LV040A

更新时间: 2024-11-23 22:53:59
品牌 Logo 应用领域
爱特美尔 - ATMEL 闪存
页数 文件大小 规格书
10页 436K
描述
4 Megabit 512K x 8 3-volt Only 256 Byte Sector CMOS Flash Memory

AT29LV040A 数据手册

 浏览型号AT29LV040A的Datasheet PDF文件第2页浏览型号AT29LV040A的Datasheet PDF文件第3页浏览型号AT29LV040A的Datasheet PDF文件第4页浏览型号AT29LV040A的Datasheet PDF文件第5页浏览型号AT29LV040A的Datasheet PDF文件第6页浏览型号AT29LV040A的Datasheet PDF文件第7页 
AT29LV040A  
Features  
Single Voltage, Range 3V to 3.6V Supply  
3-Volt-Only Read and Write Operation  
Software Protected Programming  
Fast Read Access Time - 200 ns  
Low Power Dissipation  
15 mA Active Current  
20 µA CMOS Standby Current  
Sector Program Operation  
Single Cycle Reprogram (Erase and Program)  
2048 Sectors (256 bytes/sector)  
4 Megabit  
(512K x 8)  
Internal Address and Data Latches for 256-Bytes  
Two 16 KB Boot Blocks with Lockout  
Fast Sector Program Cycle Time - 20 ms Max.  
3-volt Only  
256 Byte Sector  
CMOS Flash  
Memory  
Internal Program Control and Timer  
DATA Polling for End of Program Detection  
Typical Endurance > 10,000 Cycles  
CMOS and TTL Compatible Inputs and Outputs  
Commercial and Industrial Temperature Ranges  
Description  
The AT29LV040A is a 3-volt-only in-system Flash Programmable and Erasable Read  
Only Memory (PEROM). Its 4 megabits of memory is organized as 524,288 words by  
8 bits. Manufactured with Atmel’s advanced nonvolatile CMOS EEPROM technology,  
the device offers access times up to 200 ns, and a low 54 mW power dissipation.  
When the device is deselected, the CMOS standby current is less than 20 µA. The  
device endurance is such that any sector can typically be written to in excess of  
10,000 times. The programming algorithm is compatible with other devices in Atmel’s  
3-volt-only Flash memories.  
AT29LV040A  
To allow for simple in-system reprogrammability, the AT29LV040A does not require  
high input voltages for programming. Three-volt-only commands determine the opera-  
tion of the device. Reading data out of the device is similar to reading from an EPROM.  
Reprogramming the AT29LV040A is performed on a sector basis; 256-bytes of data  
are loaded into the device and then simultaneously programmed.  
During a reprogram cycle, the address locations and 256-bytes of data are captured  
at microprocessor speed and internally latched, freeing the address and data bus for  
other operations. Following the initiation of a program cycle, the device will automat-  
ically erase the sector and then program the latched data using an internal control  
timer. The end of a program cycle can be detected by DATA polling of I/O7. Once the  
end of a program cycle has been detected, a new access for a read or program can  
begin.  
TSOP Top View  
Type 1  
Pin Configurations  
Pin Name Function  
A0 - A18  
CE  
Addresses  
Chip Enable  
Output Enable  
Write Enable  
OE  
WE  
I/O0 - I/O7 Data Inputs/Outputs  
NC No Connect  
0334C  
4-83  

与AT29LV040A相关器件

型号 品牌 获取价格 描述 数据表
AT29LV040A_08 ATMEL

获取价格

4-megabit (512K x 8) 3-volt Only 256-byte Sector Flash Memory
AT29LV040A-15JC ETC

获取价格

EEPROM|FLASH|512KX8|CMOS|LDCC|32PIN|PLASTIC
AT29LV040A-15JI ATMEL

获取价格

4-megabit (512K x 8) 3-volt Only 256-byte Sector Flash Memory
AT29LV040A-15JU ATMEL

获取价格

4-megabit (512K x 8) 3-volt Only 256-byte Sector Flash Memory
AT29LV040A-15TC ETC

获取价格

EEPROM|FLASH|512KX8|CMOS|TSSOP|32PIN|PLASTIC
AT29LV040A-15TI ETC

获取价格

EEPROM|FLASH|512KX8|CMOS|TSSOP|32PIN|PLASTIC
AT29LV040A-15TU ATMEL

获取价格

4-megabit (512K x 8) 3-volt Only 256-byte Sector Flash Memory
AT29LV040A-15TUT/R ATMEL

获取价格

Flash, 512KX8, 150ns, PDSO32, 8 X 20 MM, GREEN, PLASTIC, MO-142BD, TSOP1-32
AT29LV040A-20DC ATMEL

获取价格

Flash, 512KX8, 200ns, CDIP32, 0.600 INCH, CERDIP-32
AT29LV040A-20DI ETC

获取价格

x8 Flash EEPROM