Features
• Dual-Port Nonvolatile Memory - RFID and Serial
• Two-Wire Serial Interface:
– Compatible with AT24C08, and similar products from others
– Supports standard byte and page read/write commands
– Programmable Access Protection to limit reads or writes from either port
– Coil connection detection
• RFID Interface:
– 125 kHz carrier frequency for long range access
– 2-wire connection to external coil antenna and tuning capacitor
– Multi-tag management to handle several tags in the field at once
– 11 RFID commands for tag control and memory read/write
– Ultra low power single bit write - 20µA
• Highly-Reliable EEPROM Memory
– 8K bits (1K bytes)
– Organized as 8 blocks of 128 bytes each
– 16-byte page write, 10ms write time
1K x 8
Dual Access
EEPROM with
RFID and Serial
Interfaces
– Additional memory for access protection and ID number
– 10 years retention, 100K write cycle endurance
– -40° to +85° operation
• Standard 8-lead SOIC package
• 2.4 to 5.5V Supply Voltage
Description
The chip functions as Dual Access EEPROM, with both a wired serial port and a wireless RFID
port used to access the memory. Access permissions are set from the serial inteface side to
isolate blocks of memory from improper access depending on the situation. The RFID interface
is designed to be powered solely from the attached coil, permitting remote reads and writes of
the device.
AT24RF08
Block Diagram
Pin Configurations
8-Pin SOIC
Pin Name
Function
L1
Coil Connection
L2
Coil Connection
Protection Input
Ground
PROT
GND
SDA
SCL
WP
Serial Data,Open Drain I/O
Serial Clock Input
Write Protect Input
Supply: 2.4 - 5.5V
Vcc
1072AS - 4/98 - 100
Note: This is a summary document. For more information contact:
Kerry Maletsky at kmaletsky@atmel.com
1