Features
• Serial Peripheral Interface (SPI) Compatible
• Supports SPI Modes 0(0,0) and 3(1,1)
• Low-Voltage and Standard-Voltage Operation
– 5.0 (VCC = 4.5V to 5.5V)
– 2.7 (VCC = 2.7V to 5.5V)
– 1.8 (VCC = 1.8V to 3.6V)
• 2.1 MHz Clock Rate (5V) Compatibility
• 8-Byte Page Mode
• Block Write Protection
– Protect 1/4, 1/2, or Entire Array
• Write Protect (WP) Pin and Write Disable Instructions for
Both Hardware and Software Data Protection
• Self-Timed Write Cycle (10 ms Max)
• High Reliability
SPI Serial
EEPROMs
1K (128 x 8)
– Endurance: 1 Million Write Cycles
– Data Retention: 100 Years
– ESD Protection: >4000V
• Automotive Grade and Extended Temperature Devices Available
• 8-Pin PDIP and JEDEC SOIC Packages
2K (256 x 8)
4K (512 x 8)
Description
The AT25010/020/040 provides 1024/2048/4096 bits of serial electrically erasable
programmable read only memory (EEPROM) organized as 128/256/512 words of 8
bits each. The device is optimized for use in many industrial and commercial applica-
tions where low power and low voltage operation are essential. The AT25010/020/040
is available in space saving 8-pin PDIP and 8-pin JEDEC (SOIC) packages.
AT25010
AT25020
AT25040
The AT25010/020/040 is enabled through the Chip Select pin (CS) and accessed via
a 3-wire interface consisting of Serial Data Input (SI), Serial Data Output (SO), and
Serial Clock (SCK). All programming cycles are completely self-timed, and no sepa-
rate ERASE cycle is required before WRITE.
BLOCK WRITE protection is enabled by programming the status register with one of
four blocks of write protection. Separate program enable and program disable instruc-
tions are provided for additional data protection. Hardware data protection is provided
via the WP pin to protect against inadvertent write attempts. The HOLD pin may be
used to suspend any serial communication without resetting the serial sequence.
SPI, 1K Serial
E2PROM
Pin Configurations
8-Pin PDIP
Pin Name Function
CS
Chip Select
CS
SO
1
2
3
4
8
7
6
5
VCC
HOLD
SCK
SI
SCK
SI
Serial Data Clock
Serial Data Input
Serial Data Output
Ground
WP
GND
SO
GND
VCC
WP
8-Pin SOIC
Power Supply
Write Protect
CS
SO
WP
1
8
7
6
5
VCC
HOLD
SCK
SI
2
3
4
HOLD
Suspends Serial Input
GND
Rev. 0606E–08/98
1