FINAL
Am29F016
16-Megabit (2,097,152 x 8-Bit) CMOS 5.0 Volt-only,
Sector Erase Flash Memory
DISTINCTIVE CHARACTERISTICS
■ 5.0 Volt ± 10% for read and write operations
— Minimizes system level power requirements
■ Compatible with JEDEC-standards
■ Embedded Program Algorithms
— Automatically programs and verifies data at
specified address
■ Data Polling and Toggle Bit feature for
detection of program or erase cycle
completion
— Pinout and software compatible with
single-power supply Flash
— Superior inadvertent write protection
■ 48-pin TSOP
■ Ready/Busy output (RY/BY)
— Hardware method for detection of program or
erase cycle completion
■ 44-pin SO
■ Minimum 100,000 write/erase cycles
■ Erase Suspend/Resume
guaranteed
— Supports reading or programming data to a
■ High performance
sector not being erased
— 70 ns maximum access time
■ Sector erase architecture
— Uniform sectors of 64 Kbytes each
■ Low power consumption
— 25 mA typical active read current
— 30 mA typical program/erase current
— Any combination of sectors can be erased.
Also supports full chip erase
■ Enhanced power management for standby
mode
■ Group sector protection
— <1 µA typical standby current
— Hardware method that disables any combination
of sector groups from write or erase operations
(a sector group consists of 4 adjacent sectors of
64 Kbytes each)
— Standard access time from standby mode
■ Hardware RESET pin
— Resets internal state machine to the read mode
■ Embedded Erase Algorithms
— Automatically pre-programs and erases the chip
or any sector
GENERAL DESCRIPTION
The Am29F016 is a 16 Mbit, 5.0 Volt-only Flash memory
organized as 2 Megabytes of 8 bits each. The 2 Mbytes
of data is divided into 32 sectors of 64 Kbytes for flexible
erase capability. The 8 bits of data appear on DQ0–DQ7.
The Am29F016 is offered in 48-pin TSOP and 44-pin SO
packages. This device is designed to be programmed
in-system with the standard system 5.0 Volt VCC supply.
12.0 Volt VPP is not required for program or erase
operations. The device can also be reprogrammed in
standard EPROM programmers.
chip enable (CE), write enable (WE), and output
enable (OE) controls.
The Am29F016 is entirely command set compatible
with the JEDEC single-power supply Flash standard.
Commands are written to the command register using
standard microprocessor write timings. Register
contents serve as input to an internal state-machine
that controls the erase and programming circuitry.
Write cycles also internally latch addresses and data
needed for the programming and erase operations.
Reading data out of the device is similar to reading
from 12.0 Volt Flash or EPROM devices.
The standard Am29F016 offers access times of 70
ns, 90 ns, 120 ns, and 150 ns, allowing high-speed
microprocessors to operate without wait states. To
eliminate bus contention, the device has separate
The Am29F016 is programmed by executing the pro-
gram command sequence. This will invoke the Embed-
Publication# 18805 Rev: D Amendment/0
Issue Date: April 1997