5秒后页面跳转
捷配首页

Datasheet > AM29F016-120SC
AM29F016-120SC PDF预览

AM29F016-120SC

更新时间： 2024-11-28 23:04:19
品牌 Logo 应用领域
超微 - AMD 闪存内存集成电路光电二极管
页数 文件大小 规格书
36页 220K
描述
16-Megabit (2,097,152 x 8-Bit) CMOS 5.0 Volt-only, Sector Erase Flash Memory

阅读下载

中文翻译

获取价格

AM29F016-120SC 技术参数

是否Rohs认证： 不符合生命周期：Obsolete
零件包装代码：SOIC包装说明：SOP, SOP44,.63
针数：44Reach Compliance Code：unknown
ECCN代码：EAR99HTS代码：8542.32.00.51
风险等级：5.56最长访问时间：120 ns
命令用户界面：YES数据轮询：YES
JESD-30 代码：R-PDSO-G44JESD-609代码：e0
长度：28.2 mm内存密度：16777216 bit
内存集成电路类型：FLASH内存宽度：8
功能数量：1部门数/规模：32
端子数量：44字数：2097152 words
字数代码：2000000工作模式：ASYNCHRONOUS
最高工作温度：70 °C最低工作温度：
组织：2MX8输出特性：3-STATE
封装主体材料：PLASTIC/EPOXY封装代码：SOP
封装等效代码：SOP44,.63封装形状：RECTANGULAR
封装形式：SMALL OUTLINE并行/串行：PARALLEL
峰值回流温度（摄氏度）：NOT SPECIFIED电源：5 V
编程电压：5 V认证状态：Not Qualified
就绪/忙碌：YES座面最大高度：2.8 mm
部门规模：64K最大待机电流：0.000005 A
子类别：Flash Memories最大压摆率：0.04 mA
最大供电电压 (Vsup)：5.5 V最小供电电压 (Vsup)：4.5 V
标称供电电压 (Vsup)：5 V表面贴装：YES
技术：CMOS温度等级：COMMERCIAL
端子面层：Tin/Lead (Sn/Pb)端子形式：GULL WING
端子节距：1.27 mm端子位置：DUAL
处于峰值回流温度下的最长时间：NOT SPECIFIED切换位：YES
类型：NOR TYPE宽度：13.3 mm
Base Number Matches：1

AM29F016-120SC 数据手册

 浏览型号AM29F016-120SC的Datasheet PDF文件第2页浏览型号AM29F016-120SC的Datasheet PDF文件第3页浏览型号AM29F016-120SC的Datasheet PDF文件第4页浏览型号AM29F016-120SC的Datasheet PDF文件第5页浏览型号AM29F016-120SC的Datasheet PDF文件第6页浏览型号AM29F016-120SC的Datasheet PDF文件第7页 
FINAL  
Am29F016  
16-Megabit (2,097,152 x 8-Bit) CMOS 5.0 Volt-only,  
Sector Erase Flash Memory  
DISTINCTIVE CHARACTERISTICS  
■ 5.0 Volt ± 10% for read and write operations  
— Minimizes system level power requirements  
■ Compatible with JEDEC-standards  
■ Embedded Program Algorithms  
— Automatically programs and verifies data at  
specified address  
■ Data Polling and Toggle Bit feature for  
detection of program or erase cycle  
completion  
— Pinout and software compatible with  
single-power supply Flash  
— Superior inadvertent write protection  
■ 48-pin TSOP  
■ Ready/Busy output (RY/BY)  
— Hardware method for detection of program or  
erase cycle completion  
■ 44-pin SO  
■ Minimum 100,000 write/erase cycles  
■ Erase Suspend/Resume  
guaranteed  
— Supports reading or programming data to a  
■ High performance  
sector not being erased  
— 70 ns maximum access time  
■ Sector erase architecture  
— Uniform sectors of 64 Kbytes each  
■ Low power consumption  
— 25 mA typical active read current  
— 30 mA typical program/erase current  
— Any combination of sectors can be erased.  
Also supports full chip erase  
■ Enhanced power management for standby  
mode  
■ Group sector protection  
— <1 µA typical standby current  
— Hardware method that disables any combination  
of sector groups from write or erase operations  
(a sector group consists of 4 adjacent sectors of  
64 Kbytes each)  
— Standard access time from standby mode  
■ Hardware RESET pin  
— Resets internal state machine to the read mode  
■ Embedded Erase Algorithms  
— Automatically pre-programs and erases the chip  
or any sector  
GENERAL DESCRIPTION  
The Am29F016 is a 16 Mbit, 5.0 Volt-only Flash memory  
organized as 2 Megabytes of 8 bits each. The 2 Mbytes  
of data is divided into 32 sectors of 64 Kbytes for flexible  
erase capability. The 8 bits of data appear on DQ0–DQ7.  
The Am29F016 is offered in 48-pin TSOP and 44-pin SO  
packages. This device is designed to be programmed  
in-system with the standard system 5.0 Volt VCC supply.  
12.0 Volt VPP is not required for program or erase  
operations. The device can also be reprogrammed in  
standard EPROM programmers.  
chip enable (CE), write enable (WE), and output  
enable (OE) controls.  
The Am29F016 is entirely command set compatible  
with the JEDEC single-power supply Flash standard.  
Commands are written to the command register using  
standard microprocessor write timings. Register  
contents serve as input to an internal state-machine  
that controls the erase and programming circuitry.  
Write cycles also internally latch addresses and data  
needed for the programming and erase operations.  
Reading data out of the device is similar to reading  
from 12.0 Volt Flash or EPROM devices.  
The standard Am29F016 offers access times of 70  
ns, 90 ns, 120 ns, and 150 ns, allowing high-speed  
microprocessors to operate without wait states. To  
eliminate bus contention, the device has separate  
The Am29F016 is programmed by executing the pro-  
gram command sequence. This will invoke the Embed-  
Publication# 18805 Rev: D Amendment/0  
Issue Date: April 1997  
1234567...36

中文翻译

下载PDF

与AM29F016-120SC相关器件

型号 品牌 获取价格 描述 数据表
AM29F016-120SCB AMD

获取价格

 		16-Megabit (2,097,152 x 8-Bit) CMOS 5.0 Volt-only, Sector Erase Flash Memory
AM29F016-120SCB SPANSION

获取价格

 		Flash, 2MX8, 120ns, PDSO48, SOP-48
AM29F016-120SI AMD

获取价格

 		16-Megabit (2,097,152 x 8-Bit) CMOS 5.0 Volt-only, Sector Erase Flash Memory
AM29F016-120SIB AMD

获取价格

 		16-Megabit (2,097,152 x 8-Bit) CMOS 5.0 Volt-only, Sector Erase Flash Memory
AM29F016-120SIB SPANSION

获取价格

 		Flash, 2MX8, 120ns, PDSO44, SOP-44
AM29F016-150 AMD

获取价格

 		16-Megabit (2,097,152 x 8-Bit) CMOS 5.0 Volt-only, Sector Erase Flash Memory
AM29F016-150EC AMD

获取价格

 		16-Megabit (2,097,152 x 8-Bit) CMOS 5.0 Volt-only, Sector Erase Flash Memory
AM29F016-150EC SPANSION

获取价格

 		Flash, 2MX8, 150ns, PDSO48, TSOP-48
AM29F016-150ECB AMD

获取价格

 		16-Megabit (2,097,152 x 8-Bit) CMOS 5.0 Volt-only, Sector Erase Flash Memory
AM29F016-150EE ETC

获取价格

 		x8 Flash EEPROM

与AM29F016-120SC相关文章

您还可以找


热门产品
PCB打样/小批量
铝基板
BOM智能配单
PCBA制造
钣金
精密CNC
模具注塑
薄膜开关
精选活动
PCBA打样特惠
四六层板品质升级
铝基板品质升级
一体化电子制造
DFM下载
服务支持
企业认证
产品展示
工厂展示
工艺能力
积分商城
关于捷配
捷配简介
企业文化
公司动态
人才招聘
联系我们
帮助中心
下单流程
付款流程
开票流程
常见问题
全球PCB制造服务专线 400-613-0088

工作时间：9:00-21:00

CEO邮箱：ceo@jiepei.com

投诉邮箱：tousu@jiepei.com

捷配网-微信公众号 微信公众号
捷配网-微信公众号 抖音公众号
资质认证：
合作快递：
支付方式：
Copyright © 2024 Jiepei.com Inc. All Rights Reserved. 版权所有:杭州捷配信息科技有限公司 浙公网安备 33010502006866号 浙ICP备10014259号-119 营业执照ICP证