W332M64V-XSBX
32Mx64 Synchronous DRAM
FEATURES
GENERAL DESCRIPTION
High Frequency = 100, 125, 133MHz
The 256MByte (2Gb) SDRAM is a high-speed CMOS, dynamic
random-access, memory using 4 chips containing 536,870,912
bits. Each chip is internally configured as a quad-bank DRAM with
a synchronous interface. Each of the chip’s 134,217,728-bit banks
is organized as 8,192 rows by 1,024 columns by 16 bits.
Package:
• 208 Plastic Ball Grid Array (PBGA), 13 x 22mm
3.3V ±0.3V power supply
Fully Synchronous; all signals registered on positive edge
Read and write accesses to the SDRAM are burst oriented;
accesses start at a selected location and continue for a
programmed number of locations in a programmed sequence.
Accesses begin with the registration of an ACTIVE command,
which is then followed by a READ or WRITE command. The
address bits registered coincident with the ACTIVE command
are used to select the bank and row to be accessed (BA0, BA1
select the bank;A0-12 select the row). The address bits registered
coincident with the READ or WRITE command are used to select
the starting column location for the burst access.
of system clock cycle
Internal pipelined operation; column address can be
changed every clock cycle
Internal banks for hiding row access/precharge
Programmable Burst length 1,2,4,8 or full page
8192 refresh cycles
Commercial, Industrial and Military Temperature Ranges
Organized as 32M x 64
The SDRAM provides for programmable READ or WRITE burst
lengths of 1, 2, 4 or 8 locations, or the full page, with a burst
terminate option.AnAUTO PRECHARGE function may be enabled
to provide a self-timed row precharge that is initiated at the end
of the burst sequence.
Weight: W332M64V-XSBX - 1.4 grams typical
BENEFITS
73% SPACE SAVINGS
The 2Gb SDRAM uses an internal pipelined architecture to achieve
high-speed operation. This architecture is compatible with the 2n rule
of prefetch architectures, but it also allows the column address to
be changed on every clock cycle to achieve a high-speed, fully
random access. Precharging one bank while accessing one of
the other three banks will hide the precharge cycles and provide
seamless, high-speed, random-access operation.
Reduced part count
Reduced trace lengths for lower parasitic capacitance
Suitable for hi-reliability applications
* This product is to change without notice.
The 2Gb SDRAM is designed to operate at 3.3V. An auto refresh
mode is provided, along with a power-saving, power-down mode.
All inputs and outputs are LVTTL compatible. SDRAMs offer
substantial advances in DRAM operating performance, including
the ability to synchronously burst data at a high data rate with
automatic column-address generation, the ability to interleave
between internal banks in order to hide precharge time and the
capability to randomly change column addresses on each clock
cycle during a burst access.
Continued on page 4
DENSITY COMPARISONS
Discrete Approach (mm)
W332M64V-XSBX
S
11.9
11.9
11.9
11.9
A
V
I
N
G
S
22
54
TSOP
54
TSOP
54
TSOP
54
TSOP
22.3
13
Area
4 x 265mm2 = 1,060mm2
286mm2
73%
Microsemi Corporation reserves the right to change products or specifications without notice.
December 2011 © 2011 Microsemi Corporation. All rights reserved.
Rev. 6
1
Microsemi Corporation • (602) 437-1520 • www.whiteedc.com
www.microsemi.com/pmgp