5秒后页面跳转
TPIC44L01DB PDF预览

TPIC44L01DB

更新时间: 2024-09-14 22:15:19
品牌 Logo 应用领域
德州仪器 - TI 驱动器接口集成电路光电二极管
页数 文件大小 规格书
20页 269K
描述
4-CHANNEL SERIAL AND PARALLEL LOW-SIDE PRE-FET DRIVER

TPIC44L01DB 技术参数

是否Rohs认证: 符合生命周期:Obsolete
零件包装代码:SSOP包装说明:SOP-24
针数:24Reach Compliance Code:compliant
ECCN代码:EAR99HTS代码:8542.39.00.01
Factory Lead Time:1 week风险等级:8.41
Is Samacsys:N高边驱动器:NO
接口集成电路类型:BUFFER OR INVERTER BASED MOSFET DRIVERJESD-30 代码:R-PDSO-G24
JESD-609代码:e4长度:8.2 mm
湿度敏感等级:1功能数量:1
端子数量:24最高工作温度:125 °C
最低工作温度:-40 °C封装主体材料:PLASTIC/EPOXY
封装代码:SSOP封装等效代码:SSOP28,.3
封装形状:RECTANGULAR封装形式:SMALL OUTLINE, SHRINK PITCH
峰值回流温度(摄氏度):260电源:5 V
认证状态:Not Qualified座面最大高度:2 mm
子类别:MOSFET Drivers最大供电电压:5.5 V
最小供电电压:4.5 V标称供电电压:5 V
电源电压1-最大:24 V电源电压1-分钟:8 V
电源电压1-Nom:12 V表面贴装:YES
温度等级:AUTOMOTIVE端子面层:Nickel/Palladium/Gold (Ni/Pd/Au)
端子形式:GULL WING端子节距:0.65 mm
端子位置:DUAL处于峰值回流温度下的最长时间:NOT SPECIFIED
断开时间:3.5 µs接通时间:4 µs
宽度:5.3 mmBase Number Matches:1

TPIC44L01DB 数据手册

 浏览型号TPIC44L01DB的Datasheet PDF文件第2页浏览型号TPIC44L01DB的Datasheet PDF文件第3页浏览型号TPIC44L01DB的Datasheet PDF文件第4页浏览型号TPIC44L01DB的Datasheet PDF文件第5页浏览型号TPIC44L01DB的Datasheet PDF文件第6页浏览型号TPIC44L01DB的Datasheet PDF文件第7页 
TPIC44L01, TPIC44L02, TPIC44L03  
4-CHANNEL SERIAL AND PARALLEL LOW-SIDE PRE-FET DRIVER  
SLIS062A NOVEMBER 1996 – REVISED SEPTEMBER 1997  
4-Channel Serial-in Parallel-in Low-Side  
Asynchronous Open-Drain Fault Flag  
Pre-FET Driver  
Device Output Can be Wire ORed with  
Multiple Devices  
Devices Are Cascadable  
Internal 55-V Inductive Load Clamp and  
Fault Status Returned Through Serial  
Output Terminal  
V
FETs  
Protection Clamp for External Power  
GS  
Internal Global Power-On Reset of Device  
and External RESET Terminal  
Independent Shorted-Load/Short-to-  
Battery Fault Detection on All Drain  
Terminals  
High-Impedance CMOS-Compatible Inputs  
With Hysteresis  
Independent OFF-State Open-Load Fault  
Sense  
TPIC44L01 and TPIC44L03 Disables the  
Gate Output When a Shorted-Load Fault  
Occurs  
Over-Battery-Voltage Lockout Protection  
and Fault Reporting  
TPIC44L02 Transitions the Gate Output to a  
Low-Duty-Cycle PWM Mode When a  
Shorted-Load Fault Occurs  
Under-Battery Voltage Lockout Protection  
for the TPIC44L01 and TPIC44L02  
description  
DB PACKAGE  
(TOP VIEW)  
The TPIC44L01, TPIC44L02, and TPIC44L03 are  
low-side predrivers that provide serial and parallel  
input interfaces to control four external FET power  
switches such as offered in the TI TPIC family of  
power arrays. These devices are designed  
primarily for low-frequency switching, inductive  
load applications such as solenoids and relays.  
Fault status for each channel is available in a  
serial-data format. Each driver channel has  
independent off-state open-load detection and  
on-state shorted-load/short-to-battery detection.  
Battery overvoltage and undervoltage detection  
and shutdown is provided on the TPIC44L01/L02.  
On the TPIC44L03 driver, only over-battery-volt-  
age shutdown is provided Each channel also  
provides inductive-voltage-transient protection  
for the external FET.  
FLT  
VCOMPEN  
VCOMP  
IN0  
V
BAT  
N/C  
1
24  
23  
22  
21  
20  
19  
18  
17  
16  
15  
14  
2
RESET  
DRAIN0  
GATE0  
DRAIN1  
GATE1  
GATE2  
DRAIN2  
GATE3  
DRAIN3  
3
4
IN1  
5
IN2  
6
IN3  
7
CS  
8
SDO  
9
SDI  
10  
11  
12  
SCLK  
13 GND  
V
CC  
These devices provide control of output channels through a serial input interface or a parallel input interface.  
A command to enable the output from either interface enables the respective channels gate output to the  
external FET. The serial interface is recommended when the number of signals between the control device and  
the predriver must be minimized and the speed of operation is not critical. In applications where the predriver  
must respond very quickly or asynchronously, the parallel input interface is recommended.  
For serial operation, the control device must transition CS from high to low to activate the serial input interface.  
When this occurs, SDO is enabled, fault data is latched into the serial interface, and the fault flag is refreshed.  
Data is clocked into the serial registers on low-to-high transitions of SCLK through SDI. Each string of data must  
consist of at least four-bits of data. In applications where multiple devices are cascaded together, the string of  
data must consist of4 bits for each device. A high data bit turns the respective output channel on and a low data  
Please be aware that an important notice concerning availability, standard warranty, and use in critical applications of  
Texas Instruments semiconductor products and disclaimers thereto appears at the end of this data sheet.  
TI is a trademark of Texas Instruments Incorporated.  
Copyright 1997, Texas Instruments Incorporated  
PRODUCTION DATA information is current as of publication date.  
Products conform to specifications per the terms of Texas Instruments  
standard warranty. Production processing does not necessarily include  
testing of all parameters.  
1
POST OFFICE BOX 655303 DALLAS, TEXAS 75265  

TPIC44L01DB 替代型号

型号 品牌 替代类型 描述 数据表
TPIC44L02DB TI

类似代替

4-CHANNEL SERIAL AND PARALLEL LOW-SIDE PRE-FET DRIVER

与TPIC44L01DB相关器件

型号 品牌 获取价格 描述 数据表
TPIC44L01DBG4 TI

获取价格

4-Channel Serial/Parallel Low-Side Pre-FET Driver 24-SSOP -40 to 125
TPIC44L01DBR TI

获取价格

1.2-mA/1.2-mA 4-channel gate driver with disable in Short-Load, Open-Load, Over-Bat-voltag
TPIC44L01DBRG4 TI

获取价格

4-CHAMMEL SERIAL AND PARALLEL LOW-SIDE PRE-FET DRIVER
TPIC44L02 TI

获取价格

4-CHANNEL SERIAL AND PARALLEL LOW-SIDE PRE-FET DRIVER
TPIC44L02DB TI

获取价格

4-CHANNEL SERIAL AND PARALLEL LOW-SIDE PRE-FET DRIVER
TPIC44L02DBG4 TI

获取价格

4-CHAMMEL SERIAL AND PARALLEL LOW-SIDE PRE-FET DRIVER
TPIC44L02DBR TI

获取价格

4-CHAMMEL SERIAL AND PARALLEL LOW-SIDE PRE-FET DRIVER
TPIC44L02DBRG4 TI

获取价格

4-CHAMMEL SERIAL AND PARALLEL LOW-SIDE PRE-FET DRIVER
TPIC44L03 TI

获取价格

4-CHANNEL SERIAL AND PARALLEL LOW-SIDE PRE-FET DRIVER
TPIC44L03DB TI

获取价格

4-CHANNEL SERIAL AND PARALLEL LOW-SIDE PRE-FET DRIVER