Datasheet > 驱动程序和接口 > MOSFET 驱动器> TPIC44L01DBR

TPIC44L01DBR

更新时间： 2024-11-05 13:00:11

品牌	Logo	应用领域
德州仪器 - TI		驱动器
页数	文件大小	规格书
20页	269K
描述
1.2-mA/1.2-mA 4-channel gate driver with disable in Short-Load, Open-Load, Over-Bat-voltage 24-SSOP -40 to 125

阅读下载

中文翻译

获取价格

技术参数
数据手册

如果您发现信息不准确，欢迎纠错

TPIC44L01DBR 技术参数

是否无铅：	不含铅	是否Rohs认证：	符合
生命周期：	Active	零件包装代码：	SSOP
包装说明：	SSOP, SSOP24,.3	针数：	24
Reach Compliance Code：	compliant	ECCN代码：	EAR99
HTS代码：	8542.39.00.01	Factory Lead Time：	12 weeks
风险等级：	5.65	高边驱动器：	NO
接口集成电路类型：	BUFFER OR INVERTER BASED MOSFET DRIVER	JESD-30 代码：	R-PDSO-G24
JESD-609代码：	e4	长度：	8.2 mm
湿度敏感等级：	1	功能数量：	1
端子数量：	24	最高工作温度：	125 °C
最低工作温度：	-40 °C	最大输出电流：	0.0012 A
标称输出峰值电流：	0.0012 A	封装主体材料：	PLASTIC/EPOXY
封装代码：	SSOP	封装等效代码：	SSOP24,.3
封装形状：	RECTANGULAR	封装形式：	SMALL OUTLINE, SHRINK PITCH
峰值回流温度（摄氏度）：	260	电源：	5 V
认证状态：	Not Qualified	座面最大高度：	2 mm
子类别：	MOSFET Drivers	最大压摆率：	4.2 mA
最大供电电压：	5.5 V	最小供电电压：	4.5 V
标称供电电压：	5 V	电源电压1-最大：	24 V
电源电压1-分钟：	8 V	电源电压1-Nom：	12 V
表面贴装：	YES	温度等级：	AUTOMOTIVE
端子面层：	Nickel/Palladium/Gold (Ni/Pd/Au)	端子形式：	GULL WING
端子节距：	0.65 mm	端子位置：	DUAL
处于峰值回流温度下的最长时间：	NOT SPECIFIED	断开时间：	3.5 µs
接通时间：	4 µs	宽度：	5.3 mm
Base Number Matches：	1

TPIC44L01DBR 数据手册

TPIC44L01, TPIC44L02, TPIC44L03

4-CHANNEL SERIAL AND PARALLEL LOW-SIDE PRE-FET DRIVER

SLIS062A – NOVEMBER 1996 – REVISED SEPTEMBER 1997

4-Channel Serial-in Parallel-in Low-Side

Asynchronous Open-Drain Fault Flag

Pre-FET Driver

Device Output Can be Wire ORed with

Multiple Devices

Devices Are Cascadable

Internal 55-V Inductive Load Clamp and

Fault Status Returned Through Serial

Output Terminal

FETs

Protection Clamp for External Power

Internal Global Power-On Reset of Device

and External RESET Terminal

Independent Shorted-Load/Short-to-

Battery Fault Detection on All Drain

Terminals

High-Impedance CMOS-Compatible Inputs

With Hysteresis

Independent OFF-State Open-Load Fault

Sense

TPIC44L01 and TPIC44L03 Disables the

Gate Output When a Shorted-Load Fault

Occurs

Over-Battery-Voltage Lockout Protection

and Fault Reporting

TPIC44L02 Transitions the Gate Output to a

Low-Duty-Cycle PWM Mode When a

Shorted-Load Fault Occurs

Under-Battery Voltage Lockout Protection

for the TPIC44L01 and TPIC44L02

description

DB PACKAGE

(TOP VIEW)

The TPIC44L01, TPIC44L02, and TPIC44L03 are

low-side predrivers that provide serial and parallel

input interfaces to control four external FET power

switches such as offered in the TI TPIC family of

power arrays. These devices are designed

primarily for low-frequency switching, inductive

load applications such as solenoids and relays.

Fault status for each channel is available in a

serial-data format. Each driver channel has

independent off-state open-load detection and

on-state shorted-load/short-to-battery detection.

Battery overvoltage and undervoltage detection

and shutdown is provided on the TPIC44L01/L02.

On the TPIC44L03 driver, only over-battery-volt-

age shutdown is provided Each channel also

provides inductive-voltage-transient protection

for the external FET.

FLT

VCOMPEN

VCOMP

IN0

BAT

N/C

RESET

DRAIN0

GATE0

DRAIN1

GATE1

GATE2

DRAIN2

GATE3

DRAIN3

IN1

IN2

IN3

SDO

SDI

SCLK

13 GND

These devices provide control of output channels through a serial input interface or a parallel input interface.

A command to enable the output from either interface enables the respective channels gate output to the

external FET. The serial interface is recommended when the number of signals between the control device and

the predriver must be minimized and the speed of operation is not critical. In applications where the predriver

must respond very quickly or asynchronously, the parallel input interface is recommended.

For serial operation, the control device must transition CS from high to low to activate the serial input interface.

When this occurs, SDO is enabled, fault data is latched into the serial interface, and the fault flag is refreshed.

Data is clocked into the serial registers on low-to-high transitions of SCLK through SDI. Each string of data must

consist of at least four-bits of data. In applications where multiple devices are cascaded together, the string of

data must consist of4 bits for each device. A high data bit turns the respective output channel on and a low data

Please be aware that an important notice concerning availability, standard warranty, and use in critical applications of

Texas Instruments semiconductor products and disclaimers thereto appears at the end of this data sheet.

TI is a trademark of Texas Instruments Incorporated.

PRODUCTION DATA information is current as of publication date.

Products conform to specifications per the terms of Texas Instruments

standard warranty. Production processing does not necessarily include

testing of all parameters.

POST OFFICE BOX 655303 • DALLAS, TEXAS 75265

12 3 4 5 6 7...20

中文翻译

下载PDF

与TPIC44L01DBR相关器件

型号	品牌	获取价格	描述	数据表
TPIC44L01DBRG4	TI	获取价格	4-CHAMMEL SERIAL AND PARALLEL LOW-SIDE PRE-FET DRIVER
TPIC44L02	TI	获取价格	4-CHANNEL SERIAL AND PARALLEL LOW-SIDE PRE-FET DRIVER
TPIC44L02DB	TI	获取价格	4-CHANNEL SERIAL AND PARALLEL LOW-SIDE PRE-FET DRIVER
TPIC44L02DBG4	TI	获取价格	4-CHAMMEL SERIAL AND PARALLEL LOW-SIDE PRE-FET DRIVER
TPIC44L02DBR	TI	获取价格	4-CHAMMEL SERIAL AND PARALLEL LOW-SIDE PRE-FET DRIVER
TPIC44L02DBRG4	TI	获取价格	4-CHAMMEL SERIAL AND PARALLEL LOW-SIDE PRE-FET DRIVER
TPIC44L03	TI	获取价格	4-CHANNEL SERIAL AND PARALLEL LOW-SIDE PRE-FET DRIVER
TPIC44L03DB	TI	获取价格	4-CHANNEL SERIAL AND PARALLEL LOW-SIDE PRE-FET DRIVER
TPIC44L03DBR	TI	获取价格	暂无描述
TPIC46L01	TI	获取价格	6-CHANNEL SERIAL AND PARALLEL LOW-SIDE PRE-FET DRIVER

与TPIC44L01DBR相关文章

英伟达新AI芯片Rubin或提前半年亮相
2024-11-05

13
苹果iPhone 17将全系采用三星/LG显示LTPO OLED面板
2024-11-05

9
三星深化印度制造布局，供应链本地化进程加速
2024-10-29

35
芯擎科技“星辰一号”自动驾驶芯片点亮成功，2025年量产在即
2024-10-29

31

产品中心

服务支持

精选活动

关于我们

帮助中心

TPIC44L01DBR

TPIC44L01DBR 技术参数

TPIC44L01DBR 数据手册

与TPIC44L01DBR相关器件

与TPIC44L01DBR相关文章

您还可以找

产品中心

服务支持

精选活动

关于我们

帮助中心

TPIC44L01DBR

TPIC44L01DBR 技术参数

TPIC44L01DBR 数据手册

与TPIC44L01DBR相关器件

与TPIC44L01DBR相关文章

您还可以找

您在本页遇到什么问题？