SGM61020
2A High Efficiency
Synchronous Buck Converter
GENERAL DESCRIPTION
FEATURES
The SGM61020 is a high efficiency synchronous Buck
DC/DC converter with 2A output current capability and
adjustable output voltage. The input supply voltage is in
the range of 2.5V to 5.5V. Using adaptive off-time peak
current control, the efficiency of this device is higher
than 80% for loads over 1mA and reaches 95% in the
moderate load ranges (5V to 3.3V).
● 2.5V to 5.5V Input Voltage Range
● Adjustable Output Voltage from 0.6V to VIN
● Up to 95% Efficiency
● Low RDSON MOSFET Switches (100mΩ/55mΩ)
● Power-Save Mode for Light Load Efficiency
● 42μA (TYP) Operating Quiescent Current
● 100% Duty Cycle Capability for Low Dropout
● 1.5MHz PWM Switching Frequency
● Power Good Output (SGM61020P Only)
● Over-Current Protection
This device operates with a quasi-fixed 1.5MHz pulse
width modulation (PWM) mode for moderate or heavy
loads. But at light loads, pulse skip modulation is used
for power-save mode (PSM). The PSM operating
quiescent current is very low, typically 42μA, which is
well suitable for battery-powered applications to
increase standby time. Despite such low quiescent
current, the transient response to large load variations
is excellent. The device shutdown current is typically
0.03μA.
● Thermal Shutdown Protection
● Input Under-Voltage Lockout (UVLO) Protection
● Small Packaging:
SGM61020: Available in Green SOT-23-5 and
SOT-563-6 Packages
SGM61020P: Available in a Green SOT-563-6
Package
The SGM61020 provides an adjustable output voltage
by an external resistor divider. The device is capable for
low dropout operation with 100% duty cycle. Some
other features include internal soft-start for limiting
startup inrush current, over-current and thermal
shutdown protections, enable input and power good
output (for SGM61020P version only).
APPLICATIONS
Battery-Powered Applications
Point-of-Load
Processor Power Supplies
Hard Disk Drives (HDD)/Solid State Drives (SSD)
The SGM61020 is available in Green SOT-23-5 and
SOT-563-6 packages.
TYPICAL APPLICATION
L1
2.2μH
VIN
VOUT
1.8V
VIN
SW
2.5V to 5.5V
CIN
4.7μF
COUT
10μF
R1
200kΩ
SGM61020P
R3
510kΩ
FB
EN
R2
PG
GND
100kΩ
Power Good
Figure 1. Typical Application Circuit
SG Micro Corp
www.sg-micro.com
AUGUST2022–REV. A.1