KSZ8895MQX/RQX/FQX/MLX
Integrated 5-Port 10/100 Managed Ethernet
Switch with MII/RMII Interface
• Programmable Weighted Fair Queuing for Ratio
Control
Features
Advanced Switch Features
• Re-Mapping of 802.1p Priority Field Per Port
Basis
• IEEE 802.1q VLAN Support for up to 128 Active
VLAN Groups (Full-Range 4096 of VLAN IDs)
Integrated 5-Port 10/100 Ethernet Switch
• Static MAC Table Supports up to 32 Entries
• VLAN ID Tag/Untagged Options, Per Port Basis
• New Generation Switch with Five MACs and Five
PHYs that are Fully Compliant with the IEEE
802.3u Standard
• IEEE 802.1p/q Tag Insertion or Removal on a Per
Port Basis Based on Ingress Port (Egress)
• PHYs Designed with Patented Enhanced Mixed-
Signal Technology
• Programmable Rate Limiting at the Ingress and
Egress on a Per Port Basis
• Non-Blocking Switch Fabric Ensures Fast Packet
Delivery by Utilizing a 1K MAC Address Lookup
Table and a Store-and-Forward Architecture
• Jitter-Free Per Packet Based Rate Limiting Sup-
port
• Broadcast Storm Protection with Percentage Con-
trol (Global and Per Port Basis)
• On-Chip 64Kbyte Memory for Frame Buffering
(Not Shared with 1K Unicast Address Table)
• IEEE 802.1d Rapid Spanning Tree Protocol RSTP
Support
• Full-Duplex IEEE 802.3x Flow Control (PAUSE)
with Force Mode Option
• Tail Tag Mode (1 Byte Added Before FCS) Sup-
port at Port 5 to Inform the Processor Which
Ingress Port Receives the Packet
• Half-Duplex Back Pressure Flow Control
• HP Auto MDI/MDI-X and IEEE Auto Crossover
Support
• 1.4 Gbps High-Performance Memory Bandwidth
and Shared Memory Based Switch Fabric with
Fully Non-Blocking Configuration
• SW-MII Interface Supports Both MAC Mode and
PHY Mode
• 7-Wire Serial Network Interface (SNI) Support for
Legacy MAC
• Dual MII with MAC 5 and PHY 5 on Port 5, SW5-
MII/RMII for MAC 5 and P5-MII/RMII for PHY 5
• Per Port LED Indicators for Link, Activity, and 10/
100 Speed
• Enable/Disable Option for Huge Frame Size up to
2000 Bytes Per Frame
• Register Port Status Support for Link, Activity,
Full-/Half-Duplex and 10/100 Speed
• LinkMD® Cable Diagnostic Capabilities
• IGMP v1/v2 Snooping (IPv4) Support for Multicast
Packet Filtering
• IPv4/IPv6 QoS Support
• On-Chip Terminations and Internal Biasing Tech-
nology for Cost Down and Lowest Power Con-
sumption
• Support Unknown Unicast/Multicast Address and
Unknown VID Packet Filtering
• Self-Address Filtering
Switch Monitoring Features
Comprehensive Configuration Register Access
• Port Mirroring/Monitoring/Sniffing: Ingress and/or
Egress Traffic to Any Port or MII
• Serial Management Interface (MDC/MDIO) to All
PHYs Registers and SMI Interface (MDC/MDIO)
to All Registers
• High-Speed SPI (up to 25 MHz) and I2C Master
Interface to all Internal Registers
• MIB Counters for Fully Compliant Statistics Gath-
ering; 34 MIB Counters Per Port
• Loopback Support for MAC, PHY, and Remote
Diagnostic of Failure
• I/O Pins Strapping and EEPROM to Program
Selective Registers in Unmanaged Switch Mode
• Interrupt for the Link Change on Any Ports
Low-Power Dissipation
• Control Registers Configurable on the Fly (Port-
Priority, 802.1p/d/q, AN…)
• Full-Chip Hardware Power-Down
• Full-Chip Software Power-Down and Per Port
Software Power-Down
QoS/CoS Packet Prioritization Support
• Per Port, 802.1p and DiffServ-Based
• Energy-Detect Mode Support <100 mW Full-Chip
Power Consumption When All Ports Have No
• 1/2/4-Queue QoS Prioritization Selection
2016 Microchip Technology Inc.
DS00002246A-page 1