KSZ8993M
Integrated 3-Port 10/100 Managed Switch with PHYs
- IGMP V1/V2 Snooping Support for Multicast
Packet Filtering
- Double-Tagging Support
• Switch Management Features
- Port Mirroring/Monitoring/Sniffing: Ingress and/
or Egress Traffic to Any Port or MII
- Management Information Base Counters for
Fully Compliant Statistics Gathering, 34 MIB
Counters Per Port
Features
• Integrated 3-Port 10/100 Ethernet Switch
- 2nd Generation Switch with Three MACs and
Two PHYs Fully Compliant to IEEE 802.3u
Standard
- Non-Blocking Switch Fabric Ensures Fast
Packet Delivery by Utilizing a 1K MAC Address
Lookup Table and a Store-and-Forward Archi-
tecture
- Loopback Modes for Remote Diagnostic of Fail-
ure
• Low Power Dissipation
- <0.8 Watts (includes PHY transmit drivers)
- Full-Chip Hardware Power-Down (Register
Configuration Not Saved)
- Per Port Based Software Power-Save on PHY
(Idle Link Detection, Register Configuration Pre-
served)
- Full-Duplex IEEE 802.3x Flow Control (PAUSE)
with Force Mode Option
- Half-Duplex Back Pressure Flow Control
- Automatic MDI/MDI-X Crossover with Disable
and Enable Option
- 100BASE-FX Support on Port 1
- MII Interface Supports Both MAC Mode and
PHY Mode
- 7-Wire Serial Network Interface (SNI) Support
for Legacy MAC
- Comprehensive LED Indicator Support for Link,
Activity, Full-/Half-Duplex and 10/100 Speed
• Comprehensive Configuration Register Access
- Serial Management Interface (SMI) to All Inter-
nal Registers
- Voltages: Core 1.8V, I/O and Transceiver 3.3V
(Use KSZ8993ML for 3.3V-Only Operation)
• Available in a 128-Pin PQFP Package
Applications
• Universal Solutions
- Broadband Gateway/Firewall/VPN
- Integrated DSL or Cable Modem Multi-Port
Router
- MII Management (MIIM) Interface to PHY Reg-
isters
- SPI and I C Interface to all internal registers
2
- Wireless LAN Access Point + Gateway
- Residential and Enterprise VoIP Gateway/
Phone
- I/O Pins Strapping and EEPROM to Program
Selective Registers in Unmanaged Switch
Mode
- Set-Top/Game Box
- Home Networking Expansion
- Standalone 10/100 Switch
- FTTx Customer Premises Equipment
- Fiber Broadband Gateway
• Upgradeable Solutions (Note 1)
- Unmanaged Switch with Future Option to
Migrate to a Managed Solution
- Single PHY Alternative with Future Expansion
Option for Two Ports
- Control Registers Configurable on the Fly (Port-
Priority, 802.1p/d/q, AN, etc.)
• QoS/CoS Packet Prioritization Support
- Per Port, 802.1p, and DiffServ-Based
- Re-Mapping of 802.1p Priority Field Per Port
Basis
- Four Priority Levels
• Advanced Switch Features
- IEEE 802.1q VLAN Support for Up to 16 Groups
(Full Range of VLAN IDs)
• Industrial Solutions
- Applications that Require Port Redundancy and
Port Monitoring
- VLAN ID Tag/Untag Options, Per Port Basis
- IEEE 802.1p/q Tag Insertion or Removal on a
Per Port Basis (Egress)
- Sensor Devices in Redundant Ring Topology
- Programmable Rate Limiting from 0 Mbps to
100 Mbps at the Ingress and Egress Port, Rate
Options for High and Low Priority Per Port Basis
- Broadcast Storm Protection with Percent Con-
trol (Global and Per Port Basis)
Note 1: The cost and time of PCB re-spin.
- IEEE 802.1d Spanning Tree Protocol Support
- Upstream Special Tagging Mode to Inform the
Processor which Ingress Port Receives the
Packet
2019 Microchip Technology Inc.
DS00003066A-page 1