5秒后页面跳转
IS61DDB41M36-250M3 PDF预览

IS61DDB41M36-250M3

更新时间: 2024-11-18 04:08:07
品牌 Logo 应用领域
美国芯成 - ISSI 静态存储器双倍数据速率
页数 文件大小 规格书
26页 515K
描述
36 Mb (1M x 36 & 2M x 18) DDR-II (Burst of 4) CIO Synchronous SRAMs

IS61DDB41M36-250M3 技术参数

是否无铅: 含铅是否Rohs认证: 不符合
生命周期:Obsolete零件包装代码:BGA
包装说明:15 X 17 MM, 1 MM PITCH, PLASTIC, FBGA-165针数:165
Reach Compliance Code:compliantECCN代码:3A991.B.2.A
HTS代码:8542.32.00.41Factory Lead Time:14 weeks
风险等级:5.28最长访问时间:0.35 ns
其他特性:PIPELINED ARCHITECTURE最大时钟频率 (fCLK):250 MHz
I/O 类型:COMMONJESD-30 代码:R-PBGA-B165
JESD-609代码:e0长度:17 mm
内存密度:37748736 bit内存集成电路类型:DDR SRAM
内存宽度:36功能数量:1
端子数量:165字数:1048576 words
字数代码:1000000工作模式:SYNCHRONOUS
最高工作温度:70 °C最低工作温度:
组织:1MX36输出特性:3-STATE
封装主体材料:PLASTIC/EPOXY封装代码:LBGA
封装等效代码:BGA165,11X15,40封装形状:RECTANGULAR
封装形式:GRID ARRAY, LOW PROFILE并行/串行:PARALLEL
峰值回流温度(摄氏度):NOT SPECIFIED电源:1.5/1.8,1.8 V
认证状态:Not Qualified座面最大高度:1.7 mm
最大待机电流:0.2 A最小待机电流:1.71 V
子类别:SRAMs最大压摆率:0.55 mA
最大供电电压 (Vsup):1.89 V最小供电电压 (Vsup):1.71 V
标称供电电压 (Vsup):1.8 V表面贴装:YES
技术:CMOS温度等级:COMMERCIAL
端子面层:Tin/Lead (Sn/Pb)端子形式:BALL
端子节距:1 mm端子位置:BOTTOM
处于峰值回流温度下的最长时间:NOT SPECIFIED宽度:15 mm
Base Number Matches:1

IS61DDB41M36-250M3 数据手册

 浏览型号IS61DDB41M36-250M3的Datasheet PDF文件第2页浏览型号IS61DDB41M36-250M3的Datasheet PDF文件第3页浏览型号IS61DDB41M36-250M3的Datasheet PDF文件第4页浏览型号IS61DDB41M36-250M3的Datasheet PDF文件第5页浏览型号IS61DDB41M36-250M3的Datasheet PDF文件第6页浏览型号IS61DDB41M36-250M3的Datasheet PDF文件第7页 
®
.
36 Mb (1M x 36 & 2M x 18)  
ISSI  
DDR-II (Burst of 4) CIO Synchronous SRAMs  
May 2005  
Two echo clocks (CQ and CQ) that are delivered  
simultaneously with data.  
Features  
• 1M x 36 or 2M x 18.  
• +1.8V core power supply and 1.5, 1.8V VDDQ  
used with 0.75, 0.9V VREF  
,
• On-chip delay-locked loop (DLL) for wide data  
valid window.  
.
• HSTL input and output levels.  
• Common I/O read and write ports.  
• Registered addresses, write and read controls,  
byte writes, and data outputs.  
• Synchronous pipeline read with late write opera-  
tion.  
• Full data coherency.  
• Double data rate (DDR-II) interface for read and  
• Boundary scan using limited set of JTAG 1149.1  
functions.  
write input ports.  
• Fixed 4-bit burst for read and write operations.  
• Clock stop support.  
• Byte write capability.  
• Fine ball grid array (FBGA) package  
- 15mm x 17mm body size  
- 1mm pitch  
Two input clocks (K and K) for address and con-  
trol registering at rising edges only.  
Two input clocks (C and C) for data output con-  
trol.  
- 165-ball (11 x 15) array  
• Programmable impedance output drivers via 5x  
user-supplied precision resistor.  
Description  
The 36Mb IS61DDB41M36 and IS61DDB42M18  
are synchronous, high-performance CMOS static  
random access memory (SRAM) devices. These  
SRAMs have a common I/O bus. The rising edge of  
K clock initiates the read/write operation, and all  
internal operations are self-timed. Refer to the  
Timing Reference Diagram for Truth Table on p.8  
for a description of the basic operations of these  
DDR-II (Burst of 4) CIO SRAMs.  
• Data-in for burst addresses 2 and 4  
Byte writes can change with the corresponding data-  
in to enable or disable writes on a per-byte basis. An  
internal write buffer enables the data-ins to be regis-  
tered one cycle later than the write address. The first  
data-in burst is clocked one cycle later than the write  
command signal, and the second burst is timed to  
the following rising edge of the K clock. Two full  
clock cycles are required to complete a write opera-  
tion.  
Read and write addresses are registered on alter-  
nating rising edges of the K clock. Reads and writes  
are performed in double data rate. The following are  
registered internally on the rising edge of the K  
clock:  
During the burst read operation, at the first and third  
bursts the data-outs are updated from output regis-  
ters off the second and fourth rising edges of the C  
clock (starting 1.5 cycles later). At the second and  
fourth bursts, the data-outs are updated with the  
third and fifth rising edges of the corresponding C  
clock (see page 9). The K and K clocks are used to  
time the data-outs whenever the C and C clocks are  
tied high. Two full clock cycles are required to  
complete a read operation  
• Read and write addresses  
• Address load  
• Read/write enable  
• Byte writes for burst addresses 1 and 3  
• Data-in for burst addresses 1 and 3  
The following are registered on the rising edge of  
the K clock:  
The device is operated with a single +1.8V power  
supply and is compatible with HSTL I/O interfaces.  
• Byte writes for burst addresses 2 and 4  
Integrated Silicon Solution, Inc. — 1-800-379-4774  
1
Rev.  
B
07/09/04  

与IS61DDB41M36-250M3相关器件

型号 品牌 获取价格 描述 数据表
IS61DDB41M36A ISSI

获取价格

Synchronous pipeline read with late write operation
IS61DDB41M36A-300M3LI ISSI

获取价格

DDR SRAM, 1MX36, 0.45ns, CMOS, PBGA165, 15 X 17 MM, 1.40 MM HEIGHT, LEAD FREE, LFBGA-165
IS61DDB41M36C-250M3L ISSI

获取价格

DDR SRAM, 1MX36, 0.45ns, CMOS, PBGA165, 15 X 17 MM, 1.40 MM HEIGHT, LEAD FREE, LFBGA-165
IS61DDB41M36C-300M3 ISSI

获取价格

DDR SRAM, 1MX36, 0.45ns, CMOS, PBGA165, 15 X 17 MM, 1.40 MM HEIGHT, LFBGA-165
IS61DDB41M36C-333M3 ISSI

获取价格

DDR SRAM, 1MX36, 0.45ns, CMOS, PBGA165, 15 X 17 MM, 1.40 MM HEIGHT, LFBGA-165
IS61DDB41M36C-333M3L ISSI

获取价格

DDR SRAM, 1MX36, 0.45ns, CMOS, PBGA165, 15 X 17 MM, 1.40 MM HEIGHT, LEAD FREE, LFBGA-165
IS61DDB41M36C-333M3LI ISSI

获取价格

DDR SRAM, 1MX36, 0.45ns, CMOS, PBGA165, 15 X 17 MM, 1.40 MM HEIGHT, LEAD FREE, LFBGA-165
IS61DDB41M36C-400B4I ISSI

获取价格

DDR SRAM, 1MX36, 0.45ns, CMOS, PBGA165, 13 X 15 MM, 1.40 MM HEIGHT, LFBGA-165
IS61DDB41M36C-400M3LI ISSI

获取价格

DDR SRAM, 1MX36, 0.45ns, CMOS, PBGA165, 15 X 17 MM, 1.40 MM HEIGHT, LEAD FREE, LFBGA-165
IS61DDB42M18 ISSI

获取价格

36 Mb (1M x 36 & 2M x 18) DDR-II (Burst of 4) CIO Synchronous SRAMs