5秒后页面跳转
IC41LV16105-50K PDF预览

IC41LV16105-50K

更新时间: 2024-02-23 19:39:54
品牌 Logo 应用领域
矽成 - ICSI 动态存储器光电二极管内存集成电路
页数 文件大小 规格书
18页 188K
描述
Fast Page DRAM, 1MX16, 50ns, CMOS, PDSO42,

IC41LV16105-50K 技术参数

是否Rohs认证: 不符合生命周期:Transferred
包装说明:SOJ, SOJ42,.44Reach Compliance Code:unknown
风险等级:5.83最长访问时间:50 ns
I/O 类型:COMMONJESD-30 代码:R-PDSO-J42
JESD-609代码:e0内存密度:16777216 bit
内存集成电路类型:FAST PAGE DRAM内存宽度:16
端子数量:42字数:1048576 words
字数代码:1000000最高工作温度:70 °C
最低工作温度:组织:1MX16
输出特性:3-STATE封装主体材料:PLASTIC/EPOXY
封装代码:SOJ封装等效代码:SOJ42,.44
封装形状:RECTANGULAR封装形式:SMALL OUTLINE
电源:3.3 V认证状态:Not Qualified
刷新周期:1024自我刷新:NO
最大待机电流:0.0005 A子类别:DRAMs
最大压摆率:0.16 mA标称供电电压 (Vsup):3.3 V
表面贴装:YES技术:CMOS
温度等级:COMMERCIAL端子面层:Tin/Lead (Sn/Pb)
端子形式:J BEND端子节距:1.27 mm
端子位置:DUALBase Number Matches:1

IC41LV16105-50K 数据手册

 浏览型号IC41LV16105-50K的Datasheet PDF文件第6页浏览型号IC41LV16105-50K的Datasheet PDF文件第7页浏览型号IC41LV16105-50K的Datasheet PDF文件第8页浏览型号IC41LV16105-50K的Datasheet PDF文件第10页浏览型号IC41LV16105-50K的Datasheet PDF文件第11页浏览型号IC41LV16105-50K的Datasheet PDF文件第12页 
IC41C16105  
IC41LV16105  
Notes:  
1. An initial pause of 200 µs is required after power-up followed by eight RAS refresh cycle (RAS-Only or CBR) before proper device  
operation is assured. The eight RAS cycles wake-up should be repeated any time the tREꢀ refresh requirement is exceeded.  
2. VIH (MIN) and VIL (MAX) are reference levels for measuring timing of input signals. Transition times, are measured between VIH  
and VIL (or between VIL and VIH) and assume to be 1 ns for all inputs.  
3. In addition to meeting the transition rate specification, all input signals must transit between VIH and VIL (or between VIL and VIH)  
in a monotonic manner.  
4. If CAS and RAS = VIH, data output is High-Z.  
5. If CAS = VIL, data output may contain data from the last valid READ cycle.  
6. Measured with a load equivalent to one TTL gate and 50 pꢀ.  
7. Assumes that tRCD < tRCD (MAX). If tRCD is greater than the maximum recommended value shown in this table, tRAC will increase  
by the amount that tRCD exceeds the value shown.  
8. Assumes that tRCD > tRCD (MAX).  
9. If CAS is LOW at the falling edge of RAS, data out will be maintained from the previous cycle. To initiate a new cycle and clear the  
data output buffer, CAS and RAS must be pulsed for tCP.  
10. Operation with the tRCD (MAX) limit ensures that tRAC (MAX) can be met. tRCD (MAX) is specified as a reference point only; if tRCD  
is greater than the specified tRCD (MAX) limit, access time is controlled exclusively by tCAC.  
11. Operation within the tRAD (MAX) limit ensures that tRCD (MAX) can be met. tRAD (MAX) is specified as a reference point only; if tRAD  
is greater than the specified tRAD (MAX) limit, access time is controlled exclusively by tAA.  
12. Either tRCH or tRRH must be satisfied for a READ cycle.  
13. tOꢀꢀ (MAX) defines the time at which the output achieves the open circuit condition; it is not a reference to VOH or VOL.  
14. tWCS, tRWD, tAWD and tCWD are restrictive operating parameters in LATE WRITE and READ-MODIꢀY-WRITE cycle only. If tWCS > tWCS  
(MIN), the cycle is an EARLY WRITE cycle and the data output will remain open circuit throughout the entire cycle. If tRWD > tRWD  
(MIN), tAWD > tAWD (MIN) and tCWD > tCWD (MIN), the cycle is a READ-WRITE cycle and the data output will contain data read from  
the selected cell. If neither of the above conditions is met, the state of I/O (at access time and until CAS and RAS or OE go back  
to VIH) is indeterminate. OE held HIGH and WE taken LOW after CAS goes LOW result in a LATE WRITE (OE-controlled) cycle.  
15. Output parameter (I/O) is referenced to corresponding CAS input, I/O0-I/O7 by LCAS and I/O8-I/O15 by UCAS.  
16. During a READ cycle, if OE is LOW then taken HIGH before CAS goes HIGH, I/O goes open. If OE is tied permanently LOW, a  
LATE WRITE or READ-MODIꢀY-WRITE is not possible.  
17. Write command is defined as WE going low.  
18. LATE WRITE and READ-MODIꢀY-WRITE cycles must have both tOD and tOEH met (OE HIGH during WRITE cycle) in order to ensure  
that the output buffers will be open during the WRITE cycle. The I/Os will provide the previously written data if CAS remains LOW  
and OE is taken back to LOW after tOEH is met.  
19. The I/Os are in open during READ cycles once tOD or tOꢀꢀ occur.  
20. The first χCAS edge to transition LOW.  
21. The last χCAS edge to transition HIGH.  
22. These parameters are referenced to CAS leading edge in EARLY WRITE cycles and WE leading edge in LATE WRITE or READ-  
MODIꢀY-WRITE cycles.  
23. Last falling χCAS edge to first rising χCAS edge.  
24. Last rising χCAS edge to next cycle’s last rising χCAS edge.  
25. Last rising χCAS edge to first falling χCAS edge.  
26. Each χCAS must meet minimum pulse width.  
27. Last χCAS to go LOW.  
28. I/Os controlled, regardless UCAS and LCAS.  
29. The 3 ns minimum is a parameter guaranteed by design.  
30. Enables on-chip refresh and address counters.  
Integrated Circuit Solution Inc.  
DR014-0A 06/07/2001  
S2-9  

与IC41LV16105-50K相关器件

型号 品牌 获取价格 描述 数据表
IC41LV16105-50KI ISSI

获取价格

Fast Page DRAM, 1MX16, 50ns, CMOS, PDSO42, 0.400 INCH, SOJ-42
IC41LV16105-50KI ICSI

获取价格

Fast Page DRAM, 1MX16, 50ns, CMOS, PDSO42,
IC41LV16105-50T ISSI

获取价格

Fast Page DRAM, 1MX16, 50ns, CMOS, PDSO44, 0.400 INCH, TSOP2-50/44
IC41LV16105-50T ICSI

获取价格

Fast Page DRAM, 1MX16, 50ns, CMOS, PDSO44,
IC41LV16105-50TI ISSI

获取价格

Fast Page DRAM, 1MX16, 50ns, CMOS, PDSO44, 0.400 INCH, TSOP2-50/44
IC41LV16105-60K ICSI

获取价格

Fast Page DRAM, 1MX16, 60ns, CMOS, PDSO42,
IC41LV16105-60KI ETC

获取价格

1M X 16 (16-MBIT) DYNAMIC RAM WITH FAST PAGE MODE
IC41LV16105-60T ISSI

获取价格

Fast Page DRAM, 1MX16, 60ns, CMOS, PDSO44, 0.400 INCH, TSOP2-50/44
IC41LV16105-60T ICSI

获取价格

Fast Page DRAM, 1MX16, 60ns, CMOS, PDSO44,
IC41LV16105-60TI ETC

获取价格

1M X 16 (16-MBIT) DYNAMIC RAM WITH FAST PAGE MODE