CYUSB330x, CYUSB332x, CYUSB230x, CYUSB231x
EZ-USB™ HX3 Automotive USB 3.2 Gen 1
(5 Gbps) Hub
General description
EZ-USB™ HX3 Automotive is a family of USB 3.2 Gen 1 (5 Gbps) hub controllers compliant with the USB 3.1, Gen
1 specification. EZ-USB™ HX3 supports SuperSpeed (SS) (5 Gbps), High-speed (HS), Full-speed (FS), and
Low-speed (LS) on all the ports. It has integrated termination, pull-up, and pull-down resistors, and supports
configuration options through pin-straps to reduce the overall BOM of the system.
EZ-USB™ HX3 Automotive includes the following Infineon-proprietary features:
• SEZ-USB™ HX3 with shared link feature: Enables extra downstream (DS) ports for onboard connections in
embedded applications.
• EZ-USB™ HX3 with ghost charging: Enables charging of devices connected to the DS ports when no host is
connected on the upstream (US) port.
Features
• Automotive Electronics Council (AEC) Q100 qualified
• USB 3.1, Gen 1-Certified Hub, TID# 330000060
• Supports up to four USB 3.1, Gen1-compliant DS ports
- All ports support SS (5 Gbps) and are backward-compatible with HS (480 Mbps), FS (12 Mbps), and LS
(1.5 Mbps)
- SS and USB 2.0 link power management (LPM)
- Dedicated Hi-Speed transaction Translators (Multi-TT)
- LED status indicators – suspend, SS, and USB 2.0 operation
• Shared Link for embedded applications
- Each DS port can simultaneously connect to an embedded SS device and a removable USB 2.0 device
- Enables up to six device connections
• Enhanced battery charging
- Each DS port complies with the USB Battery Charging v1.2 (BC v1.2) specification
- Ghost Charge: Each DS port can emulate a Dedicated Charging Port (DCP) when the host is not connected to
the US port
- Accessory Charger Adapter Dock (ACA-Dock): Enables charging and simultaneous data transfer for a smart
phone or a tablet acting as a host compliant to BC v1.2
- Apple charging supported on all DS ports
• Integrated Arm® Cortex® -M0 CPU
- 16-KB RAM, 32-KB ROM
- Configure GPIOs for overcurrent protection, power enable, and LEDs
- Upgrade firmware using I2C EEPROM or an external I2C master
• Vendor-command support to implement a USB-to-I2C bridge
- Firmware upgrade of an external ASSP connected to HX3 through USB
- In-system Programming (ISP) of the EEPROM connected to HX3 through USB
Datasheet
www.infineon.com
Please read the Important Notice and Warnings at the end of this document
page 1
002-11899 Rev. *E
2024-03-04