HSP9501
Data Sheet
January 1999
File Number 2786.4
Programmable Data Buffer
Features
The HSP9501 is a 10-Bit wide programmable data buffer
designed for use in high speed digital systems. Two different
modes of operation can be selected through the use of the
MODSEL input. In the delay mode, a programmable data
pipeline is created which can provide 2 to 1281 clock cycles
of delay between the input and output data. In the data
recirculate mode, the output data path is internally routed
back to the input to provide a programmable circular buffer.
• DC to 32MHz Operating Frequency
• Programmable Buffer Length from 2 to 1281 Words
• Supports Data Words to 10-Bits
• Clock Select Logic for Positive or Negative Edge
System Clocks
• Data Recirculate or Delay Modes of Operation
• Expandable Data Word Width or Buffer Length
• Three-State Outputs
The length of the buffer or amount of delay is programmed
through the use of the 11-bit Length Control Input Port (LC0-
10) and the Length Control Enable (LCEN). An 11-bit value
is applied to the LC0-10 inputs, LCEN is asserted, and the
next selected clock edge loads the new count value into the
Length Control Register. The delay path of the HSP9501
consists of two registers with a programmable delay RAM
between them, therefore, the value programmed into the
Length Control Register is the desired length - 2. The range
of values which can be programmed into the Length Control
Register are from 0 to 1279, which in turn results in an
overall range of programmable delays from 2 to 1281.
• TTL Compatible Inputs/Outputs
• Low Power CMOS
Applications
• Sample Rate Conversion
• Data Time Compression/Expansion
• Software Controlled Data Alignment
• Programmable Serial Data Shifting
• Audio/Speech Data Processing Video/Image Processing
Clock select logic is provided to allow the use of a positive or
negative edge system clock as the CLK input to the
HSP9501. The active edge of the CLK input is controlled
through the use of the CLKSEL input. All synchronous timing
(i.e., data setup, hold, and output delays) are relative to the
clock edge selected by CLKSEL. An additional clock enable
input (CLKEN) provides a means of disabling the internal
clock and holding the existing contents temporarily. All
outputs of the HSP9501 are three-state outputs to allow
direct interfacing to system or multi-use busses.
Video/Image Processing
• 1-H Delay Line of 910 NTSC, 1135 PAL or 1280 Samples:
- High Resolution Monitor Delay Line
- Comb Filter Designs
- Progressive Scanning Display
- TV Standards Conversion
- Image Processing
The HSP9501 is recommended for digital video processing
or any applications which require a programmable delay or
circular data buffer.
Ordering Information
TEMP.
PKG.
NO.
o
PART NUMBER RANGE ( C)
PACKAGE
44 Ld PLCC
HSP9501JC-25
HSP9501JC-32
HSP9501JC-2596
0 to 70
0 to 70
0 to 70
N44.65
N44.65
N44.65
44 Ld PLCC
44 Ld PLCC
Tape and Reel
CAUTION: These devices are sensitive to electrostatic discharge; follow proper IC Handling Procedures.
http://www.intersil.com or 407-727-9207 | Copyright © Intersil Corporation 1999
191