5秒后页面跳转
DS1073Z-100 PDF预览

DS1073Z-100

更新时间: 2024-01-04 05:30:22
品牌 Logo 应用领域
美信 - MAXIM 光电二极管外围集成电路
页数 文件大小 规格书
18页 261K
描述
Microprocessor Circuit, CMOS, PDSO8, 0.150 INCH, SOIC-8

DS1073Z-100 技术参数

是否无铅: 含铅是否Rohs认证: 不符合
生命周期:Active零件包装代码:SOIC
包装说明:SOP,针数:8
Reach Compliance Code:unknown风险等级:5.68
JESD-30 代码:R-PDSO-G8JESD-609代码:e0
长度:4.9 mm湿度敏感等级:NOT APPLICABLE
端子数量:8最高工作温度:70 °C
最低工作温度:封装主体材料:PLASTIC/EPOXY
封装代码:SOP封装形状:RECTANGULAR
封装形式:SMALL OUTLINE峰值回流温度(摄氏度):245
认证状态:COMMERCIAL座面最大高度:1.75 mm
最大供电电压:3.6 V最小供电电压:2.7 V
标称供电电压:3 V表面贴装:YES
温度等级:COMMERCIAL端子面层:TIN LEAD
端子形式:GULL WING端子节距:1.27 mm
端子位置:DUAL处于峰值回流温度下的最长时间:NOT SPECIFIED
宽度:3.9 mmuPs/uCs/外围集成电路类型:MICROPROCESSOR CIRCUIT
Base Number Matches:1

DS1073Z-100 数据手册

 浏览型号DS1073Z-100的Datasheet PDF文件第1页浏览型号DS1073Z-100的Datasheet PDF文件第2页浏览型号DS1073Z-100的Datasheet PDF文件第3页浏览型号DS1073Z-100的Datasheet PDF文件第5页浏览型号DS1073Z-100的Datasheet PDF文件第6页浏览型号DS1073Z-100的Datasheet PDF文件第7页 
DS1073  
USER-PROGRAMMABLE REGISTERS  
The following registers can be programmed by the user to determine operating frequency and mode of  
operation. Details of how these registers are programmed can be found in a later section, in this section  
the function of the registers are described. The register settings are non-volatile, the values being stored  
automatically in EEPROM when the registers are programmed. Note: The register bits cannot be used to  
make mode or frequency changes on the fly. Changes can only be made by powering the device up in  
“Programming” mode. For them to be become effective the device must then be powered down and  
powered up again in “Operation” mode.  
For programming purposes the register bits are divided into two 9-bit words: the MUX word determines  
mode of operation and prescaler values; the DIV word sets the value of the programmable divider.  
MUX WORD Figure 2  
(MSB)  
(LSB)  
E/ I  
0*  
0*  
0*  
PDN  
M
DIV1  
EN0  
MSEL  
*These bits must be set to 0  
I
E/  
This bit selects either the internal oscillator or the external/ crystal reference.  
1 = External/Crystal  
0 = Internal Oscillator  
however, if the PDN bit is set to 0 the E/I bit will be overridden by the logic level on the PDN /SELX pin.  
Table 1  
( PDN / SELX  
PDN  
I
BIT  
0
E/  
PIN  
OSCILLATOR MODE  
X
0
EXTERNAL/CRYSTAL  
0
X
X
0
1
INTERNAL  
1
0
POWER-DOWN  
INTERNAL  
1
1
1
1
1
EXTERNAL/CRYSTAL  
DIV1  
This bit allows the master clock to be routed directly to the output (DIV1 = 1). The N programmable  
divider is bypassed so the programmed value of N is ignored. The frequency of the output (fOUT) will be  
INTCLK or EXTCLK depending on which reference has been selected. If the Internal clock is selected  
the M prescaler may still be used, so in this case fOUT = INTOSC/M (which also equals MCLK and  
INTCLK). If DIV1 = 0 the programmable divider functions normally.  
MSEL  
This bit determines whether or not the M prescaler is bypassed. MSEL = 1 will bypass the prescaler.  
MSEL = 0 will switch in the prescaler, with a divide-by number determined by the M bit.  
M
This bit sets the divide-by number for the prescaler. M = 0 results in divide-by-4, M = 1 results in divide-  
by-2. The setting of this bit is irrelevant if MSEL = 1.  
4 of 18  

与DS1073Z-100相关器件

型号 品牌 获取价格 描述 数据表
DS1073Z-60 DALLAS

获取价格

3V EconOscillator/Divider
DS1073Z-60 MAXIM

获取价格

Microprocessor Circuit, CMOS, PDSO8, 0.150 INCH, SOIC-8
DS1073Z-66 MAXIM

获取价格

Microprocessor Circuit, CMOS, PDSO8, 0.150 INCH, SOIC-8
DS1073Z-66 DALLAS

获取价格

3V EconOscillator/Divider
DS1073Z-80 DALLAS

获取价格

3V EconOscillator/Divider
DS1073Z-80 MAXIM

获取价格

Microprocessor Circuit, CMOS, PDSO8, 0.150 INCH, SOIC-8
DS1075 DALLAS

获取价格

EconOscillator/Divider
DS1075 MAXIM

获取价格

DS1075X-M Crystal Replacement Module
DS1075 LATTICE

获取价格

SiI9136 HDMI Deep Color Transmitter
DS1075-100 DALLAS

获取价格

EconOscillator/Divider