5秒后页面跳转
DS1075M-66N PDF预览

DS1075M-66N

更新时间: 2024-11-23 15:31:03
品牌 Logo 应用领域
美信 - MAXIM 光电二极管
页数 文件大小 规格书
18页 247K
描述
Analog Circuit, PDIP8, DIP-8

DS1075M-66N 技术参数

是否Rohs认证: 不符合生命周期:Obsolete
包装说明:DIP-8Reach Compliance Code:not_compliant
风险等级:5.92JESD-30 代码:R-PDIP-T8
JESD-609代码:e0端子数量:8
最高工作温度:70 °C最低工作温度:
封装主体材料:PLASTIC/EPOXY封装代码:DIP
封装等效代码:DIP8,.3封装形状:RECTANGULAR
封装形式:IN-LINE电源:5 V
认证状态:Not Qualified子类别:Other Analog ICs
最大供电电流 (Isup):50 mA标称供电电压 (Vsup):5 V
表面贴装:NO温度等级:COMMERCIAL
端子面层:Tin/Lead (Sn/Pb)端子形式:THROUGH-HOLE
端子节距:2.54 mm端子位置:DUAL
Base Number Matches:1

DS1075M-66N 数据手册

 浏览型号DS1075M-66N的Datasheet PDF文件第2页浏览型号DS1075M-66N的Datasheet PDF文件第3页浏览型号DS1075M-66N的Datasheet PDF文件第4页浏览型号DS1075M-66N的Datasheet PDF文件第5页浏览型号DS1075M-66N的Datasheet PDF文件第6页浏览型号DS1075M-66N的Datasheet PDF文件第7页 
DS1075  
EconOscillator/Divider  
www.maxim-ic.com.com  
FEATURES  
PIN ASSIGNMENT  
C Dual Fixed frequency outputs  
(30 KHz - 100 MHz)  
1
2
8
7
OSCIN  
XTAL  
OE  
PDN/SELX  
I/O  
OUT0  
V
CC  
C User-programmable on-chip dividers  
(from 1 - 513)  
3
4
6
5
C User-programmable on-chip prescaler  
(1, 2, 4)  
GND  
DS1075Z 150-MIL SOIC  
DS1075M 300-MIL DIP  
C No external components  
C M0.5% Initial tolerance  
C M1% variation over temperature and voltage  
C Internal clock, External clock or crystal  
reference options  
FREQUENCY OPTIONS  
Part No.  
Max O/P freq.  
C Single 5V supply  
DS1075-100  
DS1075-80  
DS1075-66  
DS1075-60  
100.000 MHz  
80.000 MHz  
66.667 MHz  
60.000 MHz  
C Power-down mode  
C Synchronous output gating  
DESCRIPTION  
The DS1075 is a fixed frequency oscillator requiring no external components for operation. Numerous  
operating frequencies are possible in the range of approximately 30 KHz to 100 MHz through the use of  
an on-chip programmable prescaler and divider.  
The DS1075 features a master oscillator followed by a prescaler and then a programmable divider. The  
prescaler and programmable divider are user-programmable with the desired values being stored in  
nonvolatile memory. This allows the user to buy an off the shelf component and program it on site prior  
to board production. Design changes can be readily accommodated by programming, or reprogramming,  
the desired values into the on-chip nonvolatile registers. Evaluation boards, DS1075K and DS1070K are  
available to simplify this task.  
The DS1075 is shipped from the factory configured for half the maximum operating frequency. Contact  
the factory for specially programmed devices. As alternatives to the on-board oscillator an external clock  
signal or a crystal may be used as a reference. The choice of reference source (internal or external) is  
user-selectable at the time of programming (or on the fly if the SEL mode is chosen).  
The DS1075 features a dual-purpose Input/Output pin. If the device is powered up in Program mode this  
pin can be used to input serial data to the on-chip registers. After a Write command this data is stored in  
nonvolatile memory. When the chip is subsequently powered up in operating mode these values are  
automatically restored to the on-chip registers and the Input/Output pin becomes the oscillator output.  
The DS1075 is available in 8-pin DIP or SOIC packages, allowing the generation of a clock signal easily,  
economically and using minimal board area.  
1 of 18  
100899  

与DS1075M-66N相关器件

型号 品牌 获取价格 描述 数据表
DS1075M-80 DALLAS

获取价格

EconOscillator/Divider
DS1075M-80IND DALLAS

获取价格

Clock Generator, 80MHz, CMOS, PDIP8, 0.300 INCH, DIP-8
DS1075X-M10 MAXIM

获取价格

DS1075X-M Crystal Replacement Module
DS1075X-M60 MAXIM

获取价格

DS1075X-M Crystal Replacement Module
DS1075X-M66 MAXIM

获取价格

DS1075X-M Crystal Replacement Module
DS1075X-M80 MAXIM

获取价格

DS1075X-M Crystal Replacement Module
DS1075Z DALLAS

获取价格

Microprocessor Circuit, CMOS, PDSO8, 0.150 INCH, SOIC-8
DS1075Z MAXIM

获取价格

Microprocessor Circuit, CMOS, PDSO8, 0.150 INCH, SOIC-8
DS1075Z-100 DALLAS

获取价格

EconOscillator/Divider
DS1075Z-100+ MAXIM

获取价格

Clock Generator, 100MHz, CMOS, PDSO8, 0.150 INCH, SOIC-8