DRV8809
DRV8810
www.ti.com ............................................................................................................................................................... SLVS854A–JULY 2008–REVISED JULY 2008
COMBINATION MOTOR DRIVERS WITH DC-DC CONVERTERS
1
FEATURES
•
Three Integrated DC-DC Converters
2
•
Configurable to Eight Modes of Combination
Motor Driver
–
–
–
On/Off Selectable Using C_SELECT Pin and
Serial Interface
–
Bipolar Stepper Motor Driver
Outputs Programmable With External
Resistor Network From 1.5 V to VDIN × 0.8
–
–
16-Step Current-Mode Control
1.5-A Output Capability for All Three
Channels
800-mA Average Output Current as
Stepper Motor Drive
•
7-V to 40-V Operating Voltage Range for
DC-DC Converters
–
–
DC Motor Driver
–
800-mA Maximum Continuous Current
and 8-A/500-ns or 3-A/100-ms Peak
Current for Each DC Motor Drive
•
•
Two Serial Interfaces for Communications
Thermally-Enhanced Surface-Mount 64-Pin
QFP PowerPAD™ Package
(Eco-Friendly – RoHS and No Sb/Br)
Low ON resistance Rds(ON) = 0.55 Ω at
TJ = 25°C (Typ)
•
•
•
Power-Down Function (Deep-Sleep Mode)
Reset Signal Output (Active Low)
Reset (All Clear) Control Input
DESCRIPTION/ORDERING INFORMATION
The DRV8809/DRV8810 provides an integrated motor driver solution. The chip has four H-bridges internally and
is configurable to eight different modes of combination motor driver control.
The output driver block for each H-bridge consists of N-channel power MOSFETs configured as full H-bridges to
drive the motor windings. The stepper motor control has a 16-step mode programmable through the three-wire
serial interface (SPI). The SPI input pins are 3.3-V compatible and 5-V tolerant.
The DRV8809/DRV8810 has three DC-DC switch-mode buck converters to generate a programmable output
voltage from 1.5 V to 80% of VDIN (Channel A) or up to 10 V (for Channel B and Channel C), with up to 1.5-A
load current capability. The outputs are selected using the C_SELECT terminal at start-up or using serial
interface during operation.
An internal shutdown function is provided for overcurrent protection (OCP), short-circuit protection,
overvoltage/undervoltage lockout (UVLO), and thermal shutdown (TSD). Also, the device has a reset function
that operates at power on and at input to the In-Reset pin.
ORDERING INFORMATION
TA
PACKAGE(1)(2)
ORDERABLE PART NUMBER
DRV8809A0PAP
DRV8810A0PAP
TOP-SIDE MARKING
DRV8809A0PAP
–20°C to 80°C
Plastic QFP 64 (S-PQFP-G64)
DRV8810A0PAP
(1) For the most current package and ordering information, see the Package Option Addendum at the end of this document, or see the TI
website at www.ti.com.
(2) Package drawings, thermal data, and symbolization are available at www.ti.com/packaging.
1
Please be aware that an important notice concerning availability, standard warranty, and use in critical applications of Texas
Instruments semiconductor products and disclaimers thereto appears at the end of this data sheet.
2
PowerPAD is a trademark of Texas Instruments Inc.
PRODUCTION DATA information is current as of publication date.
Products conform to specifications per the terms of the Texas
Instruments standard warranty. Production processing does not
necessarily include testing of all parameters.
Copyright © 2008, Texas Instruments Incorporated