DA7211
Ultra-low power stereo codec
Company confidential
General description
DA7211 features a high fidelity and powerful 72 mW per channel headphone amplifier. The device
may be operated from a single 1.8 V supply. Total device consumption is only 2.5 mW which helps
extend music playback time for battery operated equipment.
The fully integrated fractional PLL has been designed to use minimal power while supporting a wide
range of input and output frequencies. Internal suppression circuits help maintain audio
synchronisation in the presence of system noise on the external clock.
Six analogue input pins allow multiple audio sources to be internally mixed, eliminating the need for
external switches. Both single-ended and fully-differential line and microphone inputs are supported
with built-in variable gain amplifiers to optimise the dynamic range prior to digitisation. This provides
hardware support for ambient noise cancellation.
The DA7211 provides two volume-controlled differential/single-ended stereo line-out drivers and
ground-centred stereo amplifiers to directly drive standard 3-wire 16 Ω headphones. For example the
dc coupled, dedicated pop-free drivers may be connected simultaneously to stereo headphones,
stereo speakers and a mono line out without external switches.
All filtering functions are performed digitally including 5-band EQ and a digital input AGC with
programmable attack and decay parameters. A configurable signal processing engine allows various
audio enhancements and effects such as acoustic filtering, transducer equalisation, wind noise
suppression and 3D sound
The multi-slot I2S/PCM interface supports all common sample rates between 8 and 96 kHz in master
or slave mode operation.
Key features
■
■
■
Stereo multi-bit Delta Sigma DAC with SNR
100 dB ('A' weighted @ 48 kHz)
■
■
Audio serial data bus supports I2S,
left/right justified, DSP and TDM modes
Stereo multi-bit Delta Sigma ADC with SNR
96 dB ('A' weighted @ 48 kHz)
Stereo or mono differential microphone
interface
Ultra low-power stereo headphone driver with ■ Programmable ultra-low noise bias supply for
electret microphones
□
Stereo DAC to HP playback power:
2.5 mW
■
Volume controlled stereo auxiliary inputs and
outputs supporting FM Radio and fixed gain
speaker amplifiers
□
□
□
2x58 mW output power (16 Ω)
‘Capless’ output via GND centred signals
■
■
■
Multi-mode audio routing and mixers
Pop & click suppression circuitry
Four level charge pump with continuous
tracking of audio signal (Class G)
ASSP DSP filter engine for digital audio
enhancements (acoustic filtering, wind noise
suppression, 5-band equaliser, 3D sound,
automatic gain control)
□
Short circuit protection
■
■
■
Support of 8, 11.025, 12, 16, 22.05, 24, 32,
44.1, 48 and 96 kHz sample rates
On-chip PLL with signal shaper and audio
Sample Rate Matching
■
Supports supply from single voltage
(1.8/2.5 V)
2-wire software control interface
■
■
Extensive modular power control
Package: 36 bump WL-CSP 3x3 – 0.5 mm
pitch
Applications
■
■
Personal media players
■
■
Music handsets
Portable consumer devices
Personal navigation devices
Datasheet
Revision 3e
15-Oct-2015
CFR0011-120-00 Rev 5
1 of 105
© 2015 Dialog Semiconductor