DA7217
Ultra-Low Power Stereo Codec
General Description
DA7217 is a high-performance, low-power audio codec optimized for use in headsets or wearable
devices. It has differential headphone outputs for use inside headset devices, offering excellent left to
right channel separation and common mode noise rejection. DA7217 also has a stereo DAC to
headphone output path and ultra-low power operating modes to support always-on audio detect
applications.
DA7217 contains two analog microphone input paths, or up to four digital microphone input paths, or
a combination of both. The other chip in this family, DA7218, has single-ended headphone outputs,
and has been designed with headphone detect for use in accessories.
Key Features
■
High performance stereo DAC to headphone ■ Flexible digital mixing from all seven inputs to
playback path with 110 dB dynamic range
all six outputs with independent gain on each
mixer path
■
■
4 mW stereo playback power consumption
■
■
■
■
Ability to run the ADCs at a different sample
rate to the DACs on a single I2S interface
DAC digital filters with audio and voice mode
options, five-band equalizer and five
programmable biquad stages
Digital tone generator with built-in support for
DTMF
■
■
Dedicated low-latency digital sideband filter
with three programmable biquad stages
System controller for simplified, pop-free start-
up and shutdown
High performance microphone to ADC record
path with 105 dB dynamic range
Phase-locked loop with sample rate tracking
supporting MCLK frequencies from 2 MHz to
54 MHz
■
■
2.5 mW stereo record power consumption
ADC digital filters with audio and voice mode
options
■
■
■
Automatic tuning of on-chip reference
oscillator for clock-free operation in low-power
modes
■
■
■
■
500 µW always-on record mode with
automatic level detection
4-wire digital audio interface with support for
I2S, four-channel I2S, TDM and other audio
formats
2-wire I2C compatible control interface with
support for High Speed mode up to 3.4 MHz
Hybrid analog/digital automatic level control to
dynamically control the record level
Shutdown mode offering current consumption
during standby of 2.5 µA
Two low-noise microphone bias regulators
with programmable output voltage and ultra-
low power mode
■
■
24-bit data at up to 96 kHz sample rate
The headphone amplifier can be run directly
from the supply, thus eliminating the need for
charge pump capacitors
■
■
A high efficiency two-level, true-ground charge
pump for generating class-G headphone
supplies
Voice mode filtering up to 32 kHz
Applications
■
■
Hearables
■
Wireless and wired headsets
Wireless and wired headphones
Datasheet
Revision 3.5
July 17 2023
CFR0011-120-00
1 of 178
© 2023 Renesas Electronics