DA7218
Ultra-Low Power Stereo Codec
GeneralDescription
DA7218 is a high-performance, low-power audio codec optimized for use in portable applications or
wearable devices. It has single-ended headphone outputs with headphone detect for use in
accessories, offering excellent left to right channel separation and common mode noise rejection.
DA7218 also has a stereo DAC to headphone output path and ultra-low power operating modes to
support always-on audio detect applications.
DA7218 contains two analog microphone input paths, or up to four digital microphone input paths, or
a combination of both The other chip in this family, theDA7217 has differential headphone outputs
without headphone detect, and has been designed for use inside headset devices.
Key Features
■ High performance stereo DAC to headphone ■ Flexible digital mixing from all seven inputs to
playback path with 110 dB dynamic range
all six outputs with independent gain on each
mixer path
■ 4 mW stereo playback power consumption
■ Ability to run the ADCs at a different sample
■ DAC digital filters with audio and voice mode
options, five-band equalizer and five
programmable biquad stages
rate to the DACs on a single I2S interface
■ Digital tone generator with built-in support for
DTMF
■ Dedicated low-latency digital sideband filter
■ System controller for simplified, pop-free start-
with three programmable biquad stages
up and shutdown
■ High performance microphone to ADC record
■ Phase-locked loop with sample rate tracking
supporting MCLK frequencies from 2 MHz to
54 MHz
path with a 105 dB dynamic range
■ 2.5 mW stereo record power consumption
■ ADC digital filters with audio and voice mode
■ Automatic tuning of on-chip reference
oscillator for clock-free operation in low-power
modes
options
■ 500 µW always-on record mode with
automatic leveldetection
■ 4-wire digital audio interface with support for
I2S, four-channel I2S, TDM and other audio
formats
■ Hybrid analog / digital automatic level control
to dynamically control the record level
2
■ Shutdown mode offering current consumption
during standby of 2.5 µA
■ 2-wire I C compatible controlinterface with
support for High Speed mode up to 3.4 MHz
■ Two low-noise microphone bias regulators
with programmable output voltage and ultra-
low power mode
■ 24-bit data at up to 96 kHz sample rate
■ A high efficiency two-level, true-ground charge
pump for generating class-G headphone
supplies
■ Ability to differentiate between stereo and
mono headsets
■ Voice mode filtering up to 32 kHz
■ Automatic detection of headset removal and
confirmation of headset insertion
Applications
■ Wired headsets
■ Wired headphones
■ Audio accessories
■ Portable media players
■ Gaming console controllers
■ Tablets and eBooks
Datasheet
Revision 3.5
July 18, 2023
CFR0011-120-00
1 of 171
© 2023 Renesas Electronics