CY62136ESL MoBL®
2 Mbit (128K x 16) Static RAM
mode reduces power consumption by more than 99% when
deselected (CE HIGH). The input and output pins (IO0 through
IO15) are placed in a high impedance state when:
Features
■ Very high speed: 45 ns
■ Deselected (CE HIGH)
■ Wide voltage range: 2.2V to 3.6V and 4.5V to 5.5V
■ Outputs are disabled (OE HIGH)
■ Ultra low standby power
❐ Typical standby current: 1 μA
❐ Maximum standby current: 7 μA
■ Both Byte High Enable and Byte Low Enable are disabled
(BHE, BLE HIGH)
■ Ultra low active power
❐ Typical active current: 2 mA at f = 1 MHz
■ Write operation is active (CE LOW and WE LOW)
To write to the device, take Chip Enable (CE) and Write Enable
(WE) inputs LOW. If Byte Low Enable (BLE) is LOW, then data
from IO pins (IO0 through IO7) is written into the location
specified on the address pins (A0 through A16). If Byte High
Enable (BHE) is LOW, then data from IO pins (IO8 through IO15
is written into the location specified on the address pins (A0
through A16).
■ Easy memory expansion with CE and OE features
■ Automatic power down when deselected
■ CMOS for optimum speed and power
)
■ Available in Pb-free 44-pin TSOP II package
To read from the device, take Chip Enable (CE) and Output
Enable (OE) LOW while forcing the Write Enable (WE) HIGH. If
Byte Low Enable (BLE) is LOW, then data from the memory
location specified by the address pins appears on IO0 to IO7. If
Byte High Enable (BHE) is LOW, then data from memory
appears on IO8 to IO15. See the “Truth Table” on page 10 for a
complete description of read and write modes.
Functional Description
The CY62136ESL is a high performance CMOS static RAM
organized as 128K words by 16 bits. This device features
advanced circuit design to provide ultra low active current. This
is ideal for providing More Battery Life™ (MoBL®) in portable
applications such as cellular telephones. The device also has an
automatic power down feature that reduces power consumption
when addresses are not toggling. Placing the device into standby
For best practice recommendations, refer to the Cypress
application note AN1064, SRAM System Guidelines.
.
Logic Block Diagram
DATA IN DRIVERS
A10
A9
A8
A7
A6
A5
A4
A3
128K x 16
RAM Array
I/O0–I/O7
I/O8–I/O15
A2
A1
A0
COLUMN DECODER
BHE
WE
CE
OE
BLE
Cypress Semiconductor Corporation
Document #: 001-48147 Rev. *A
•
198 Champion Court
•
San Jose, CA 95134-1709
•
408-943-2600
Revised June 15, 2009
[+] Feedback