AMIS-52150
Lowpower Transceiver
with Clock and Data
Recovery
Introduction
http://onsemi.com
The AMIS−52150 is a cost-effective, ultra-low power single-chip
wireless transceiver. It combines the proven Amplitude Shift
Key/On-Off Key (ASK/OOK) modulation technology of the
AMIS−52050 with data clock recovery.
Based on key features, such as dual independent receive channels,
Quick Start crystal oscillator, Sniff Mode signal acquisition, and data
clock recovery, the AMIS−52150 is ideally suited for a wide range of
applications, including point-to-point wireless data links,
cost-optimized wireless monitor solutions, and very low power remote
wireless sensors, among others.
SSOP−20
CASE TBD
ORDERING INFORMATION
See detailed ordering and shipping information in the package
dimensions section on page 20 of this data sheet.
Key Features
Data Clock Recovery
Auto Slicing of Data
Very Low-power Single-chip Transceiver
Minimal External Components
Low-power RC Oscillator
Serial TX/RX Data Port
Quick Start Crystal Oscillator
Clock Generation for an External Microprocessor
Wake-up on RSSI
Antenna Diversity Dual Receiver
Internal VCO/PLL Tuning Varactor
Wake-up Interrupt to External Controller
These Devices are Pb-Free and are RoHS Compliant
Ultra-low Power RF Sniff Mode, with Wake-up on
RSSI
Internal Trim Functions Reduce External Component
Requirements
2
I C Control Interface
Technical Features
Operating Frequency Range:
Sniff Mode Polling: 0.5 ms to 16 s
(0.5 ms or 64 ms Steps)
PLL Lock Time: < 50 ms
Quick Start, from 350 MHz to 448 MHz
Non-quick Start, from 300 MHz to 768 MHz
TX Output Power: +12 dBm
RX Sensitivity:
Sniff Mode: −93 dBm Minimum
Receive: −117 dBm Minimum @ 1 kbps, with CDR
Data Rate:
Selectable Data Filter: Up to 20 kHz
Internal Trim Functions:
TX Power (−3 to +12 dBm)
Antenna Impedance Matching (Two Independent
Channels)
1−8 kbps with Manchester Coding
1−16 kbps with NRZ Data
Xtal, for Frequency and Quick Start
RC Oscillator Frequency
Sniff Mode, for Data Threshold
Data slice
Power Requirements:
Receive: 7.5 mA (Continuous)
Clock and Data Recovery (Reduced Data Jitter)
I C Interface: Control Bus
Serial Interface: Data Input/Output
Low Frequency IF
Internal IF Filtering
Transmit: 25 mA @ Full Power (50% Duty-cycle)
Sniff Mode: 75 mA (One Percent Duty-cycle)
Standby: 500 nA (RC Oscillator Running)
2
Operating Voltage: 2.3 V to 3.6 V
Modulation: ASK/OOK
Xtal Start Time: 15 ms (Quick Start)
Package: 20-lead, 209 mm SSOP
Semiconductor Components Industries, LLC, 2013
1
Publication Order Number:
July, 2013 − Rev. 8
AMIS−52150/D