NXP Semiconductors
Data Sheet: Technical Data
KE1xFP100M168SF0
Rev. 4, 06/2019
Kinetis KE1xF with up to 512 KB
MKE1xF512VLL16
MKE1xF512VLH16
MKE1xF256VLL16
MKE1xF256VLH16
Flash
Up to 168 MHz ARM® Cortex®-M4 Based Microcontroller
The KE1xF microcontroller is built on the ARM® Cortex®-M4
processor with stronger performance and higher memory
densities in multiple packages. This device offers up to 168 MHz
performance with integrated single-precision floating point unit
(FPU) and digital signal processor (DSP). Embedded flash
memory sizes range from 256 KB to 512 KB.
100 LQFP (LL)
14x14x1.4 mm Pitch
0.5 mm
64 LQFP (LH)
10x10x1.4 mm Pitch
0.5 mm
Core Processor and System
Memory and memory interfaces
• ARM® Cortex®-M4 core, supports up to 168 MHz
frequency with 1.25 Dhrystone MIPS per MHz
• ARM Core based on the ARMv7 Architecture and
Thumb®-2 ISA
• Up to 512 KB program flash with ECC
• Up to 64 KB SRAM with ECC
• 64 KB FlexNVM with ECC for data flash and with
EEPROM emulation
• Integrated Digital Signal Processor (DSP)
• Configurable Nested Vectored Interrupt Controller
(NVIC)
• 4 KB FlexRAM for EEPROM emulation
• 8 KB I/D cache to minimize performance impact of
memory access latencies
• Single-precision Floating Point Unit (FPU)
• 16-channel DMA controller extended up to 64 channels
with DMAMUX
• Boot ROM with built in bootloader
Mixed-signal analog
• 3× 12-bit analog-to-digital converter (ADC) with up
to 16 channel analog inputs per module, up to 1M
sps
• 3× high-speed analog comparators (CMP) with
internal 8-bit digital to analog converter (DAC)
• 1× 12-bit digital to analog converter (DAC)
Reliability, safety and security
• Error-correcting code (ECC) on Flash and SRAM
memories
• System memory protection unit (MPU) module
• Flash Access Control (FAC)
• Cyclic Redundancy Check (CRC) generator module
• 128-bit unique identification (ID) number
• Internal watchdog (WDOG) with independent clock
source
• External watchdog monitor (EWM) module
• ADC self calibration feature
Timing and control
• 4× Flex Timers (FTM) for PWM generation, offering
up to 32 standard channels
• 1× Low-Power Timer (LPTMR) working at Stop
mode, with flexible wake up control
• 3× Programmable Delay Block (PDB) with flexible
trigger system, to provide accurate delay and trigger
generation for inter-module synchronization
• 1× Low-power Periodic Interrupt Timer (LPIT) with 4
independent channels, for general purpose
• Pulse Width Timer (PWT)
• On-chip clock loss monitoring
Human-machine interface (HMI)
• Supports up to 92 interrupt request (IRQ) sources
• Up to 89 GPIO pins with interrupt functionality
• 8 high drive pins
• Digital filters
• Real timer clock (RTC)
NXP reserves the right to change the production detail specifications as may be
required to permit improvements in the design of its products.