5秒后页面跳转
TDA9899HN PDF预览

TDA9899HN

更新时间: 2024-02-25 10:58:39
品牌 Logo 应用领域
恩智浦 - NXP 消费电路商用集成电路
页数 文件大小 规格书
103页 498K
描述
Multistandard hybrid IF processing including car mobile

TDA9899HN 技术参数

Source Url Status Check Date:2013-10-15 00:00:00是否Rohs认证: 符合
生命周期:Not Recommended零件包装代码:QFN
包装说明:HVQCCN, LCC48,.27SQ,20针数:48
Reach Compliance Code:compliantHTS代码:8542.39.00.01
风险等级:5.65商用集成电路类型:CONSUMER CIRCUIT
JESD-30 代码:S-PQCC-N48长度:7 mm
功能数量:1端子数量:48
最高工作温度:70 °C最低工作温度:-20 °C
封装主体材料:PLASTIC/EPOXY封装代码:HVQCCN
封装等效代码:LCC48,.27SQ,20封装形状:SQUARE
封装形式:CHIP CARRIER, HEAT SINK/SLUG, VERY THIN PROFILE电源:5 V
认证状态:Not Qualified座面最大高度:1 mm
子类别:Other Consumer ICs最大压摆率:190 mA
最大供电电压 (Vsup):5.5 V最小供电电压 (Vsup):4.5 V
表面贴装:YES温度等级:OTHER
端子形式:NO LEAD端子节距:0.5 mm
端子位置:QUAD宽度:7 mm
Base Number Matches:1

TDA9899HN 数据手册

 浏览型号TDA9899HN的Datasheet PDF文件第4页浏览型号TDA9899HN的Datasheet PDF文件第5页浏览型号TDA9899HN的Datasheet PDF文件第6页浏览型号TDA9899HN的Datasheet PDF文件第8页浏览型号TDA9899HN的Datasheet PDF文件第9页浏览型号TDA9899HN的Datasheet PDF文件第10页 
TDA9899  
NXP Semiconductors  
Multistandard hybrid IF processing including car mobile  
[4] Condition: luminance range (5 steps) from 0 % to 100 %. Measurement value is based on 4 of 5 steps.  
[5] Measurement using 200 kHz high-pass filter, 5 MHz low-pass filter and subcarrier notch filter (“ITU-T J.64”).  
[6] To match the AFC output signal to different tuning systems a current output is provided. The test circuit is given in Figure 18. The  
AFC steepness can be changed by resistors R1 and R2.  
[7] With single-ended load for fIF < 45 MHz RL 1 kand CL 5 pF to ground and for fIF = 45 MHz to 60 MHz RL = 1 kand CL 3 pF to  
ground.  
[8] This parameter is not tested during production and is only given as application information.  
[9] Noise level is measured without input signal but AGC adjusted corresponding to the given input level.  
[10] Set with AGC nominal output voltage as reference. For C/N measurement switch input signal off.  
[11] The tolerance of the reference frequency determines the accuracy of VIF AFC, RIF AFC, FM demodulator center frequency, maximum  
FM deviation, sound trap frequency, LIF band-pass cut-off frequency and ZIF low-pass cut-off frequency as well as the accuracy of the  
synthesizer.  
5. Ordering information  
Table 2.  
Ordering information  
Type number  
Package  
Name  
Description  
Version  
TDA9899HL  
TDA9899HN  
LQFP48  
plastic low profile quad flat package; 48 leads; body 7 × 7 × 1.4 mm  
SOT313-2  
SOT619-1  
HVQFN48 plastic thermal enhanced very thin quad flat package; no leads;  
48 terminals; body 7 × 7 × 0.85 mm  
TDA9899_3  
© NXP B.V. 2008. All rights reserved.  
Product data sheet  
Rev. 03 — 15 January 2008  
7 of 103  

与TDA9899HN相关器件

型号 品牌 描述 获取价格 数据表
TDA9901 NXP Wideband differential digital controlled variable gain amplifier

获取价格

TDA9901TS NXP Wideband differential digital controlled variable gain amplifier

获取价格

TDA9901TS/C3 NXP IC,DIGITALLY CONTROLLED GAIN AMPLIFIER,SINGLE,SSOP,20PIN,PLASTIC

获取价格

TDA9901TS/C3-T NXP IC,DIGITALLY CONTROLLED GAIN AMPLIFIER,SINGLE,SSOP,20PIN,PLASTIC

获取价格

TDA9910 NXP 12-bit, up to 80 Msample/s, Analog-to-Digital Converter (ADC) direct/ultra high IF samplin

获取价格

TDA9910HW/6 NXP 12-bit, up to 80 Msample/s, Analog-to-Digital Converter (ADC) direct/ultra high IF samplin

获取价格