MT9M001 - 1/2-Inch Megapixel Digital Image Sensor
Features
1/2-Inch Megapixel CMOS Digital Image Sensor
MT9M001C12STM (Monochrome)
For the latest data sheet, refer to Micron’s Web site: www.micron.com\imaging
Table 1: Key Performance Parameters
Features
Parameter
Typical Value
•
•
DigitalClarity™ CMOS Imaging Technology
Array Format (5:4): 1,280H x 1,024V (1,310,720 active
pixels). Total (incl. dark pixels): 1,312H x 1,048V
(1,374,976 pixels)
Optical format
1/2-inch (5:4)
Active imager size
Active pixels
6.66mm(H) x 5.32mm(V)
1,280H x 1,024V
Pixel size
5.2µm x 5.2µm
•
•
•
Frame Rate: 30 fps progressive scan; programmable
Shutter: Electronic Rolling Shutter (ERS)
Window Size: SXGA; programmable to any smaller
format (VGA, QVGA, CIF, QCIF, etc.)
Programmable Controls: Gain, frame rate, frame
size
Shutter type
Maximum data rate/
master clock
Electronic rolling shutter (ERS)
48 MPS/48 MHz
Frame
rate
ADC resolution
Responsivity
SXGA
(1280 x 1024)
30 fps progressive scan;
programmable
10-bit, on-chip
2.1 V/lux-sec
•
Applications
Dynamic range
68.2dB
•
•
•
Digital still cameras
Digital video cameras
PC cameras
SNR
45dB
MAX
Supply voltage
Power consumption
3.0V−3.6V, 3.3V nominal
325mW at 3.3V;
Standby 275µW
0°C to +70°C
General Description
®
Operating temperature
Packaging
The Micron Imaging MT9M001 is an SXGA-format
48-pin CLCC
with a 1/2-inch CMOS active-pixel digital image sen-
sor. The active imaging pixel array of 1,280H x 1,024V. It
incorporates sophisticated camera functions on-chip
such as windowing, column and row skip mode, and
snapshot mode. It is programmable through a simple
two-wire serial interface.
The sensor can be operated in its default mode or pro-
grammed by the user for frame size, exposure, gain set-
ting, and other parameters. The default mode outputs
an SXGA-size image at 30 frames per second (fps). An
on-chip analog-to-digital converter (ADC) provides 10
bits per pixel. FRAME_VALID and LINE_VALID signals
are output on dedicated pins, along with a pixel clock
that is synchronous with valid data.
This megapixel CMOS image sensor features Digital-
Clarity—Micron’s breakthrough low-noise CMOS
imaging technology that achieves CCD image quality
(based on signal-to-noise ratio and low-light sensitiv-
ity) while maintaining the inherent size, cost, and inte-
gration advantages of CMOS.
Ordering Information
Table 2: Available Part Numbers
Part Number
Description
MT9M001C12STM
46-pin CLCC
80a3e031
MT9M001_DS_1.fm - Rev. C 7/05 EN
Micron Technology, Inc., reserves the right to change products or specifications without notice.
©2004 Micron Technology, Inc. All rights reserved.
1
Products and specifications discussed herein are subject to change by Micron without notice.