Freescale Semiconductor
Data Sheet:
Document Number: MSC8126
Rev. 13, 12/2007
MSC8126
FC PBGA–431
20 mm × 20 mm
Quad Digital Signal
Processor
•
Four StarCore™ SC140 DSP extended cores, each with an SC140
DSP core, 224 Kbyte of internal SRAM M1 memory (1436 Kbyte
total), 16 way 16 Kbyte instruction cache (ICache), four-entry
write buffer, external cache support, programmable interrupt
controller (PIC), local interrupt controller (LIC), and low-power
Wait and Stop processing modes.
levels or round-robin time-multiplexing between channels,
flexible channel configuration with connection to local bus or
system bus, and flyby transfer support that bypasses the FIFO.
Up to four independent TDM modules with programmable word
size (2, 4, 8, or 16-bit), hardware-base A-law/μ-law conversion,
up to 128 Mbps data rate for all channels, with glueless interface
to E1 or T1 framers, and can interface with H-MVIP/H.110
devices, TSI, and codecs such as AC-97.
Ethernet controller: support for 10/100 Mbps MII/RMII/SMII
including full- and half-duplex operation, full-duplex flow
controls, out-of-sequence transmit queues, programmable
maximum frame length including jumbo frames and VLAN tags
and priority, retransmission after collision, CRC generation and
verification of inbound/outbound packets, address recognition
(including exact match, broadcast address, individual hash check,
group hash check, and promiscuous mode), pattern matching,
insertion with expansion or replacement for transmit frames,
VLAN tag insertion, RMON statistics, local bus master DMA for
descriptor fetching and buffer access, and optional multiplexing
with GPIO (MII/RMII/SMII) or DSI/system bus signals lines
(MII/RMII).
•
•
•
•
•
475 Kbyte M2 memory for critical data/temporary data buffering.
4 Kbyte boot ROM.
M2-accessible multi-core MQBus connecting the M2 memory
with all four cores, operating at the core frequency, with data bus
access of up to 128-bit reads and up to 64-bit writes, central
efficient round-robin arbiter for core access to the bus, and atomic
control of M2 memory access by the cores and local bus.
Internal PLL configured are reset by configuration signal values.
60x-compatible system bus with 64 or 32 bit data and 32-bit
address bus, support for multi-master designs, four-beat burst
transfers (eight-beat in 32-bit data mode), port size of 64/32/16/8
bits controlled by the internal memory controller,.access to
external memory or peripherals, access by an external host to
internal resources, slave support with direct access to internal
resources including M1 and M2 memories, and on-device
arbitration for up to four master devices.
Direct slave interface (DSI) using a 32/64-bit slave interface with
21–25 bit addressing and 32/64-bit data transfers, direct access by
an external host to internal/external resources, synchronous or
asynchronous accesses with burst capability in synchronous
mode, dual or single strobe mode, write and read buffers to
improve host bandwidth, byte enable signals for 1/2/4/8-byte
write granularity, sliding window mode for access using a reduced
number of address pins, chip ID decoding to allow one CS signal
to control multiple DSPs, broadcast mode to write to multiple
DSPs, and big-endian/little-endian/munged support.
Three mode signal multiplexing: 64-bit DSI/32-bit system bus,
32-bit DSI/64-bit system bus, or 32-bit DSI/32-bit system bus.
Flexible memory controller with three UPMs, a GPCM, a
page-mode SDRAM machine, glueless interface to a variety of
memories and devices, byte enables for 64-/32-bit bus widths, 8
memory banks for external memories, and 2 memory banks for
IPBus peripherals and internal memories.
Multi-channel DMA controller with 16 time-multiplexed single
channels, up to four external peripherals, DONE or DRACK
protocol for two external peripherals,.service for up to 16 internal
requests from up to 8 internal FIFOs per channel, FIFO generated
watermarks and hungry requests, priority-based
•
•
•
•
•
•
•
•
UART with full-duplex operation up to 6.25 Mbps.
•
Up to 32 general-purpose input/output (GPIO) ports.
I2C interface that allows booting from EEPROM devices.
Two timer modules, each with sixteen configurable 16-bit timers.
Eight programmable hardware semaphores.
Global interrupt controller (GIC) with interrupt consolidation and
routing to INT_OUT, NMI_OUT, and the cores; thirty-two virtual
maskable interrupts (8 per core) and four virtual NMI (one per
core) that can be generated by a simple write access.
Boot options: external memory, external host, UART, TDM, or
I2C.
VCOP with fully programmable feed-forward channel decoding,
feed-forward channel equalization and traceback sessions. Up to
400 3GPP 12.2 kbps AMR channels (channel decoding, number
of channels linear to frequency). Up to 200 blind transport format
detect (BTFD) channels according to the 3GPP standard. Number
of channels linear to frequency.
TCOP with full support for 3GPP and CDMA2000 standards in
Turbo decode; up to 20 turbo-coding 384 kbps channels; 8 state
PCCC with polynomial as supported by the 3G standards;
iterative decoding structure based on Maximum A-Posteriori
probability (MAP), with calculations performed in the LOG
domain.
•
•
•
•
•
•
time-multiplexing between channels using 16 internal priority
© Freescale Semiconductor, Inc., 2004, 2007. All rights reserved.
5秒后页面跳转
英伟达新AI芯片Rubin或提前半年亮相
苹果iPhone 17将全系采用三星/LG显示LTPO OLED面板
三星深化印度制造布局，供应链本地化进程加速
芯擎科技“星辰一号”自动驾驶芯片点亮成功，2025年量产在即
微信公众号
抖音公众号
浙公网安备 33010502006866号 浙ICP备10014259号-119
营业执照ICP证
数据手册
如果您发现信息不准确，
