5秒后页面跳转
MSC7118 PDF预览

MSC7118

更新时间: 2024-09-09 05:50:23
品牌 Logo 应用领域
飞思卡尔 - FREESCALE 双倍数据速率控制器
页数 文件大小 规格书
60页 772K
描述
Low-Cost 16-bit DSP with DDR Controller

MSC7118 数据手册

 浏览型号MSC7118的Datasheet PDF文件第2页浏览型号MSC7118的Datasheet PDF文件第3页浏览型号MSC7118的Datasheet PDF文件第4页浏览型号MSC7118的Datasheet PDF文件第5页浏览型号MSC7118的Datasheet PDF文件第6页浏览型号MSC7118的Datasheet PDF文件第7页 
Freescale Semiconductor  
Data Sheet  
Document Number: MSC7118  
Rev. 7, 4/2008  
MSC7118  
Low-Cost 16-bit DSP with  
DDR Controller  
MAP-BGA–400  
17 mm × 17 mm  
StarCore® SC1400 DSP extended core with one SC1400 DSP  
core, 256 Kbyte of internal SRAM M1 memory, 16 way 16 Kbyte  
instruction cache (ICache), four-entry write buffer, programmable  
interrupt controller (PIC), and low-power Wait and Stop  
processing modes.  
192 Kbyte M2 memory for critical data and temporary data  
buffering.  
8 Kbyte boot ROM.  
Multi-channel DMA controller with 32 time-multiplexed  
unidirectional channels, priority-based time-multiplexing  
between channels using 32 internal priority levels, fixed- or  
round-robin-priority operation, major-minor loop structure, and  
DONE or DRACK protocol from requesting units.  
Two independent TDM modules with independent receive and  
transmit, programmable sharing of frame sync and clock,  
programmable word size (8 or 16-bit), hardware-base  
A-law/μ-law conversion, up to 50 Mbps data rate per TDM, up to  
128 channels, with glueless interface to E1/T1 frames and MVIP,  
SCAS, and H.110 buses.  
UART with full-duplex operation up to 5.0 Mbps.  
Up to 41 general-purpose input/output (GPIO) ports.  
I2C interface that allows booting from EEPROM devices up to 1  
Mbyte.  
Two quad timer modules, each with sixteen configurable 16-bit  
timers.  
fieldBIST™ unit detects and provides visibility into unlikely field  
failures for systems with high availability to ensure structural  
integrity, that the device operates at the rated speed, is free from  
reliability defects, and reports diagnostics for partial or complete  
device inoperability.  
Standard JTAG interface allows easy integration to system  
firmware and internal on-chip emulation (OCE10) module.  
Optional booting external host via 8-bit or 16-bit access through  
the HDI16, I2C, or SPI using in the boot ROM to access serial SPI  
Flash/EEPROM devices; different clocking options during boot  
with the PLL on or off using a variety of input frequency ranges.  
AHB-Lite crossbar switch that allows parallel data transfers  
between four master ports and six slave ports, where each port  
connects to an AHB-Lite bus; fixed or round robin priority  
programmable at each slave port; programmable bus parking at  
each slave port; low power mode.  
Internal PLL generates up to 300 MHz clock for the SC1400 core  
and up to 150 MHz for the crossbar switch, DMA channels, M2  
memory, and other peripherals.  
Clock synthesis module provides predivision of PLL input clock;  
independent clocking of the internal timers and DDR module;  
programmable operation in the SC1400 low power Stop mode;  
independent shutdown of different regions of the device.  
Enhanced 16-bit wide host interface (HDI16) provides a glueless  
connection to industry-standard microcomputers,  
microprocessors, and DSPs and can also operate with an 8-bit host  
data bus, making if fully compatible with the DSP56300 HI08  
from the external host side.  
DDR memory controller that supports byte enables for up to a  
32-bit data bus; glueless interface to 150 MHz 14-bit page mode  
DDR-RAM; 14-bit external address bus supporting up to 1 Gbyte;  
and 16-bit or 32-bit external data bus.  
Programmable memory interface with independent read buffers,  
programmable predictive read feature for each buffer, and a write  
buffer.  
System control unit performs software watchdog timer function;  
includes programmable bus time-out monitors on AHB-Lite slave  
buses; includes bus error detection and programmable time-out  
monitors on AHB-Lite master buses; and has address  
out-of-range detection on each crossbar switch buses.  
Event port collects and counts important signal events including  
DMA and interrupt requests and trigger events such as interrupts,  
breakpoints, DMA transfers, or wake-up events; units operate  
independently, in sequence, or triggered externally; can be used  
standalone or with the OCE10.  
© Freescale Semiconductor, Inc., 2004, 2008. All rights reserved.  

与MSC7118相关器件

型号 品牌 获取价格 描述 数据表
MSC7118VF1200 FREESCALE

获取价格

Low-Cost 16-bit DSP with DDR Controller
MSC7118VM1200 FREESCALE

获取价格

Low-Cost 16-bit DSP with DDR Controller
MSC7119 FREESCALE

获取价格

Low-Cost 16-bit DSP with DDR Controller and 10/100 Mbps Ethernet MAC
MSC7119_08 FREESCALE

获取价格

Low-Cost 16-bit DSP with DDR Controller and 10/100 Mbps Ethernet MAC
MSC7119VF1200 FREESCALE

获取价格

Low-Cost 16-bit DSP with DDR Controller and 10/100 Mbps Ethernet MAC
MSC7119VM1200 FREESCALE

获取价格

Low-Cost 16-bit DSP with DDR Controller and 10/100 Mbps Ethernet MAC
MSC7128 OKI

获取价格

5 x 7-Dot Character x 16-Digit Display Controller/Driver
MSC7128-01GS-BK OKI

获取价格

Dot Matrix LCD Driver, 16 X 36 Dots, CMOS, PQFP64, 14 X 20 MM, 1 MM PITCH, PLASTIC, QFP-64
MSC7128-XX OKI

获取价格

5 x 7-Dot Character x 16-Digit Display Controller/Driver
MSC7128-XXGS-BK OKI

获取价格

Dot Matrix LCD Driver, 16 X 36 Dots, CMOS, PQFP64, 14 X 20 MM, 1 MM PITCH, PLASTIC, QFP-64