5秒后页面跳转
MAX19711ETN PDF预览

MAX19711ETN

更新时间: 2024-09-16 12:32:23
品牌 Logo 应用领域
美信 - MAXIM /
页数 文件大小 规格书
36页 957K
描述
10-Bit, 11Msps, Full-Duplex Analog Front-End

MAX19711ETN 数据手册

 浏览型号MAX19711ETN的Datasheet PDF文件第2页浏览型号MAX19711ETN的Datasheet PDF文件第3页浏览型号MAX19711ETN的Datasheet PDF文件第4页浏览型号MAX19711ETN的Datasheet PDF文件第5页浏览型号MAX19711ETN的Datasheet PDF文件第6页浏览型号MAX19711ETN的Datasheet PDF文件第7页 
19-0527; Rev 0; 5/06  
10-Bit, 11Msps, Full-Duplex  
Analog Front-End  
General Description  
Features  
Dual 10-Bit, 11Msps Rx ADC and Dual 10-Bit,  
The MAX19711 is an ultra-low-power, highly integrated  
mixed-signal analog front-end (AFE) ideal for CDMA  
communication applications operating in full-duplex  
(FD) mode. Optimized for high dynamic performance  
and ultra-low power, the device integrates a dual 10-bit,  
11Msps receive (Rx) ADC; dual 10-bit, 11Msps transmit  
(Tx) DAC with CDMA baseband filters; three fast-settling  
12-bit aux-DAC channels for ancillary RF front-end con-  
trol; and a 10-bit, 333ksps housekeeping aux-ADC. The  
typical operating power in FD mode is 37.5mW/42.7mW  
at a 4.915MHz/11MHz clock frequency.  
11Msps Tx DAC  
Ultra-Low Power  
37.5mW/42.7mW at fCLK = 4.915MHz/11MHz,  
FD Mode  
24.3mW at fCLK = 11MHz, Slow Rx Mode  
34.5mW at fCLK = 11MHz, Slow Tx Mode  
Low-Current Standby and Shutdown Modes  
Integrated CDMA Filters with > 64dBc Stopband  
Rejection  
Programmable Tx DAC Common-Mode DC Level  
and I/Q Offset Trim  
Excellent Dynamic Performance  
The Rx ADCs feature 54.8dB SNR and 74.2dBc SFDR at  
1.875MHz input frequency with an 11MHz clock frequen-  
cy. The analog I/Q input amplifiers are fully differential  
SNR = 54.8dB at fIN = 1.875MHz (Rx ADC)  
SFDR = 75dBc at fOUT = 620kHz (Tx DAC)  
and accept 1.024V  
full-scale signals. Typical I/Q  
P-P  
channel matching is 0.01° phase and 0.01dB gain.  
Three 12-Bit, 1µs Aux-DACs  
10-Bit, 333ksps Aux-ADC with 4:1 Input Mux and  
The Tx DACs with CDMA lowpass filters feature -3dB  
cutoff frequency of 1.3MHz and > 64dBc stopband  
Data Averaging  
rejection at f  
= 4.285MHz at f  
= 4.915MHz. The  
Excellent Gain/Phase Match  
0.01ꢀ Phase, 0.01dB Gain (Rx ADC) at  
fIN = 1.87MHz  
Multiplexed Parallel Digital I/O  
Serial-Interface Control  
IMAGE  
CLK  
analog I-Q full-scale output voltage range is selectable at  
410mV or 500mV differential. The output DC common-  
mode voltage is selectable from 0.86V to 1.36V. The I/Q  
channel offset is adjustable to optimize radio lineup side-  
band/carrier suppression. Typical I-Q channel matching  
is 0.03dB gain and 0.07° phase.  
Versatile Power-Control Circuits  
Shutdown, Standby, Idle, Tx/Rx Disable  
Two independent 10-bit parallel, high-speed digital  
buses used by the Rx ADC and Tx DAC allow full-  
duplex operation for frequency-division duplex applica-  
tions. The Rx ADC and Tx DAC can be disabled  
independently to optimize power management. A 3-wire  
serial interface controls power-management modes, the  
aux-DAC channels, and the aux-ADC channels.  
Miniature 56-Pin Thin QFN Package  
(7mm x 7mm x 0.8mm)  
Pin Configuration  
TOP VIEW  
The MAX19711 operates on a single 2.7V to 3.3V analog  
supply and 1.8V to 3.3V digital I/O supply. The  
MAX19711 is specified for the extended (-40°C to  
+85°C) temperature range and is available in a 56-pin,  
thin QFN package. The Selector Guide at the end of the  
data sheet lists other pin-compatible versions in this AFE  
family. For time-division duplex (TDD) applications, refer  
to the MAX19705–MAX19708 AFE family of products.  
42 41 40 39 38 37 36 35 34 33 32 31 30 29  
28  
27  
26  
25  
24  
23  
22  
21  
ADC1  
DAC3  
DA3  
DA2  
DA1  
DA0  
43  
44  
DAC2 45  
DAC1 46  
V
47  
OV  
DD  
DD  
IDN 48  
IDP 49  
GND 50  
OGND  
AD9  
MAX19711  
AD8  
V
51  
20 AD7  
19 AD6  
18 AD5  
17 AD4  
16 AD3  
15 AD2  
DD  
Applications  
Portable Communication  
Equipment  
QDN 52  
QDP 53  
CDMA Handsets  
REFIN 54  
COM 55  
REFN 56  
CDMA Data Cards  
EXPOSED PADDLE (GND)  
Ordering Information  
1
2
3
4
5
6
7
8
9
10 11 12 13 14  
PART*  
PIN-PACKAGE  
56 Thin QFN-EP**  
56 Thin QFN-EP**  
PKG CODE  
T5677-1  
THIN QFN  
NOTE: THE PIN 1 INDICATOR IS “+” FOR LEAD-FREE DEVICES.  
MAX19711ETN  
MAX19711ETN+  
T5677-1  
Functional Diagram and Selector Guide appear at end of  
data sheet.  
*All devices are specified over the -40°C to +85°C operating range.  
**EP = Exposed paddle. +Denotes lead-free package.  
________________________________________________________________ Maxim Integrated Products  
1
For pricing, delivery, and ordering information, please contact Maxim/Dallas Direct! at  
1-888-629-4642, or visit Maxim’s website at www.maxim-ic.com.  

与MAX19711ETN相关器件

型号 品牌 获取价格 描述 数据表
MAX19711ETN+ MAXIM

获取价格

暂无描述
MAX19711EVCMODU+ MAXIM

获取价格

Low-Voltage and Low-Power Operation
MAX19711EVKIT+ MAXIM

获取价格

Low-Voltage and Low-Power Operation
MAX19712 MAXIM

获取价格

10-Bit, 22Msps, Full-Duplex Analog Front-End
MAX19712ETN MAXIM

获取价格

10-Bit, 22Msps, Full-Duplex Analog Front-End
MAX19712ETN+ MAXIM

获取价格

Telecom Circuit, 1-Func, CMOS, 7 X 7 MM, 0.80 MM HEIGHT, LEAD FREE, MO-220, TQFN-56
MAX19712ETN+T MAXIM

获取价格

Telecom Circuit, 1-Func, CMOS, 7 X 7 MM, 0.80 MM HEIGHT, LEAD FREE, MO-220, TQFN-56
MAX19712ETN-T MAXIM

获取价格

Telecom Circuit, 1-Func, CMOS, 7 X 7 MM, 0.80 MM HEIGHT, MO-220, TQFN-56
MAX19712EVCMODU+ MAXIM

获取价格

Low-Voltage and Low-Power Operation
MAX19712EVKIT+ MAXIM

获取价格

Low-Voltage and Low-Power Operation