5秒后页面跳转
L8574D PDF预览

L8574D

更新时间: 2024-10-18 22:31:39
品牌 Logo 应用领域
杰尔 - AGERE 继电器
页数 文件大小 规格书
36页 461K
描述
L8574D Resistive Subscriber Line Interface Circuit(SLIC), Ring Relay,and Protector(SRP)for Long Loop and TR-57 Applications

L8574D 数据手册

 浏览型号L8574D的Datasheet PDF文件第2页浏览型号L8574D的Datasheet PDF文件第3页浏览型号L8574D的Datasheet PDF文件第4页浏览型号L8574D的Datasheet PDF文件第5页浏览型号L8574D的Datasheet PDF文件第6页浏览型号L8574D的Datasheet PDF文件第7页 
Data Sheet  
October 1998  
L8574D Resistive Subscriber Line Interface Circuit (SLIC), Ring  
Relay, and Protector (SRP) for Long Loop and TR-57 Applications  
Included in the L8574 are a solid-state ringing  
access switch and a line break switch. Also included  
Features  
is a relay driver for an external (test) access mechan-  
ical relay.  
Low-power scan mode for low on-hook power dis-  
sipation (55 mW max)  
State control is via four latched parallel data inputs. A  
Low active power dissipation; talk or on-hook  
chip select feature allows the user to enable, disable,  
transmission (240 mW max)  
or reset the data latches to a known logic state.  
Distortion-free on-hook transmission  
The L8574 offers a low-power scan state to minimize  
power to less than 55 mW in the on-hook state. The  
L8574 also supports on-hook transmission. The  
Eight operating states via latched paralleled data  
inputs with channel select feature  
active power in both the talk or on-hook transmission  
mode is also very low (<240 mW). Current is limited  
to a fixed value of 25 mA by an internal precision  
Precision fixed 28 mA current limiter  
Integrated protection  
current-limit circuit.  
No external protection device required  
Because of the internal architecture of the L8574  
SLIC and because of the power rating of the associ-  
ated external feed resistors, the L8574 will meet most  
Integrated ringing access relay  
Ring trip detector  
surge requirements without use of an external sec-  
ondary protection device. Internal circuitry steers  
both positive and negative faults to fault ground. Neg-  
Loop closure detector with hysteresis  
Relay driver  
ative faults are not dumped into battery.  
Battery noise cancellation  
The L8574 is a two-chip line interface solution pack-  
aged in a single, 44-pin PLCC package. The Tip and  
Ring drive amplifiers, the XMT amplifier, the receive  
Thermal protection  
44-pin, surface-mount, plastic package (PLCC)  
interface, and battery noise cancellation circuits are  
fabricated in a 90 V complementary bipolar (CBIC)  
Description  
process. The ring access switch, line break switch,  
battery switch, current-limit, protection functions,  
supervision, and control functions are fabricated in a  
320 V dielectrically isolated bipolar-CMOS-DMOS  
(BCDMOS) process. The device is available in a  
44-pin PLCC package.  
The L8574 is a resistive subscriber line interface cir-  
cuit (SLIC) that is optimized for long loop applica-  
tions, such as Bellcore TR-NWT-000057  
requirements for digital loop carrier (DLC) applica-  
tions. It interfaces the low-voltage circuits on an ana-  
log line card to the Tip/Ring subscriber loop. The  
L8574 does not supply dc current to the subscriber  
loop; external resistors are used for this purpose.  

与L8574D相关器件

型号 品牌 获取价格 描述 数据表
L8575 AGERE

获取价格

Dual-Resistive,Low-Cost Subscriber Line Interface Circuit(SLIC)
L8576B AGERE

获取价格

Dual Ringing SLIC
L8581 ETC

获取价格

Telecomm/Datacomm
L8-5-SERIES ETC

获取价格

Interface IC
L8600 UTC

获取价格

Analog Circuit, PDSO20
L8601-01 HAMAMATSU

获取价格

90KV MICROFOCUS X-RAY SOURCE
L8602 UTC

获取价格

LOW POWER 6 STAGE FET LNA AND MIXER BIAS CONTROLLER
L8602G-Q20-4040-R UTC

获取价格

LOW POWER 6 STAGE FET LNA AND MIXER BIAS CONTROLLER
L8603 UTC

获取价格

6 STAGE FET LNA BIAS CONTROLLER
L8628 HAMAMATSU

获取价格

Transmitter/receiver photo IC for optical link