NOTES:
*1: Minimum voltage is guaranteed to maximum 0.1% of rated output voltage.
*2: Minimum current is guaranteed to maximum 0.2% of rated output current.
*3: Derate 4A/1°C above 40°C.
*4: For cases where conformance to various safety standards (UL, IEC, etc…) is required, to be described as 190-240Vac (50/60Hz) for 3-Phase 200V models,
380~415Vac (50/60Hz) for 3-Phase 400V models, 380~480Vac (50/60Hz) for 3-Phase 480V models and 190-240Vac (50/60Hz) for 1-Phase models.
*5: 3-Phase 200V models: At 200Vac input voltage, 3-Phase 400/480V models: At 380Vac input voltage, 1-Phase models: At 200Vac input voltage. At rated output power.
*6: Not including EMI filter inrush current, less than 0.2mS.
*7: 3-Phase 200V models: 170~265Vac, 3-Phase 400V models: 342~460Vac, 3-Phase 480V models: 342~528Vac, 1-Phase models: 170~265Vac. Constant load.
*8: From No-Load to Full-Load, constant input voltage. Measured at the sensing point in Remote Sense.
*9: For 10V~150V models: Measured with JEITA RC-9131C (1:1) probe. For 300~600V models: Measured with 100:1 probe.
*10: The maximum voltage on the power supply terminals must not exceed the rated voltage.
*11: From 10% to 90% of Rated Output Voltage at rated resistive load.
*12: From 90% to 10% of Rated Output Voltage.
*13: For load voltage change, equal to the unit voltage rating, constant input voltage.
*14: The ripple is measured at 10~100% of rated output voltage and rated output current. B.W 5Hz~1MHz.
*15: The Constant Current programming, readback and monitoring accuracy do not include the warm-up and Load regulation thermal drift.
*16: Measured at the sensing point.
*17: Signal and control ports interface cables length: Less than 3m, DC output power port cables length: Less than 30m.
*18: Maximum ambient temperature for IEEE option is 40°C.
*19: Typ. at Ta=25°C, rated output power.
*20: At Tamb < 10°C the Output Ripple & Noise is higher, there is a need of 2min warm-up.
To achieve high-speed respond, the output capacitance has been reduced.
Due to smaller capacitance, the output ripple & noise is higher, but it's not a problem for applications requiring high speed power supply as Automotive industry
9