CY7C2663KV18, CY7C2665KV18
144-Mbit QDR® II+ SRAM Four-Word Burst
Architecture (2.5 Cycle Read Latency) with ODT
144-Mbit QDR® II+ SRAM Four-Word Burst Architecture (2.5 Cycle Read Latency) with ODT
Features
Configurations
■ Separate independent read and write data ports
❐ Supports concurrent transactions
With Read Cycle Latency of 2.5 cycles:
CY7C2663KV18: 8 M × 18
■ 550-MHz clock for high bandwidth
CY7C2665KV18: 4 M × 36
■ Four-word burst for reducing address bus frequency
Functional Description
■ Double data rate (DDR) interfaces on both read and write ports
(data transferred at 1100 MHz) at 550 MHz
The CY7C2663KV18, and CY7C2665KV18 are 1.8 V
synchronous pipelined SRAMs, equipped with QDR II+
architecture. Similar to QDR II architecture, QDR II+ architecture
consists of two separate ports: the read port and the write port to
access the memory array. The read port has dedicated data
outputs to support read operations and the write port has
dedicated data inputs to support write operations. QDR II+
architecture has separate data inputs and data outputs to
completely eliminate the need to “turnaround” the data bus that
exists with common I/O devices. Each port is accessed through
a common address bus. Addresses for read and write addresses
are latched on alternate rising edges of the input (K) clock.
Accesses to the QDR II+ read and write ports are completely
independent of one another. To maximize data throughput, both
read and write ports are equipped with DDR interfaces. Each
address location is associated with four 18-bit words
(CY7C2663KV18), or 36-bit words (CY7C2665KV18) that burst
sequentially into or out of the device. Because data is transferred
into and out of the device on every rising edge of both input
clocks (K and K), memory bandwidth is maximized while
simplifying system design by eliminating bus “turn arounds”.
■ Available in 2.5-clock cycle latency
■ Two input clocks (K and K) for precise DDR timing
❐ Static random access memory (SRAM) uses rising edges
only
■ Echo clocks (CQ and CQ) simplify data capture in high-speed
systems
■ Data valid pin (QVLD) to indicate valid data on the output
■ On-die termination (ODT) feature
❐ Supported for D[x:0], BWS[x:0], and K/K inputs
■ Single multiplexed address input bus latches address inputs
for read and write ports
■ Separate port selects for depth expansion
■ Synchronous internally self-timed writes
■ Quad data rate (QDR®) II+ operates with 2.5-cycle read latency
when DOFF is asserted high
■ OperatessimilartoQDRIdevicewith1cyclereadlatencywhen
DOFF is asserted low
These devices have an ODT feature supported for D[x:0]
,
BWS[x:0], and K/K inputs, which helps eliminate external
termination resistors, reduce cost, reduce board area, and
simplify board routing.
■ Available in × 18, and × 36 configurations
■ Full data coherency, providing most current data
[1]
■ Core VDD = 1.8 V ± 0.1 V; I/O VDDQ = 1.4 V to VDD
❐ Supports both 1.5 V and 1.8 V I/O supply
Depth expansion is accomplished with port selects, which
enables each port to operate independently.
All synchronous inputs pass through input registers controlled by
the K or K input clocks. All data outputs pass through output
registers controlled by the K or K input clocks. Writes are
conducted with on-chip synchronous self-timed write circuitry.
■ High-speed transceiver logic (HSTL) inputs and variable drive
HSTL output buffers
■ Available in 165-ball fine-pitch ball grid array (FBGA) package
(15 ×17 ×1.4 mm)
■ Offered in both Pb-free and non Pb-free packages
■ JTAG 1149.1 compatible test access port
■ Phase locked loop (PLL) for accurate data placement
Selection Guide
Description
Maximum operating frequency
Maximum operating current
550 MHz
550
1090
450 MHz Unit
450
940
MHz
mA
× 18
× 36
1520
1290
Note
1. The Cypress QDR II+ devices surpass the QDR consortium specification and can support V
= 1.4 V to V
.
DD
DDQ
Cypress Semiconductor Corporation
Document Number: 001-44141 Rev. *K
•
198 Champion Court
•
San Jose, CA 95134-1709
•
408-943-2600
Revised October 26, 2012
5秒后页面跳转
英伟达新AI芯片Rubin或提前半年亮相
苹果iPhone 17将全系采用三星/LG显示LTPO OLED面板
三星深化印度制造布局，供应链本地化进程加速
芯擎科技“星辰一号”自动驾驶芯片点亮成功，2025年量产在即
微信公众号
抖音公众号
浙公网安备 33010502006866号 浙ICP备10014259号-119
营业执照ICP证
数据手册
如果您发现信息不准确，
