CY7C1353G
4-Mbit (256K x 18) Flow-through SRAM
Functional Description[1]
Features
• Supports up to 133-MHz bus operations with zero wait
states
The CY7C1353G is a 3.3V, 256K x 18 Synchronous
Flow-through Burst SRAM designed specifically to support
unlimited true back-to-back Read/Write operations without the
insertion of wait states. The CY7C1353G is equipped with the
advanced No Bus Latency™ (NoBL™) logic required to
enable consecutive Read/Write operations with data being
transferred on every clock cycle. This feature dramatically
improves the throughput of data through the SRAM, especially
in systems that require frequent Write-Read transitions.
— Data is transferred on every clock
• PincompatibleandfunctionallyequivalenttoZBT™devices
• Internally self timed output buffer control to eliminate the
need to use OE
• Registered inputs for flow-through operation
• Byte Write capability
All synchronous inputs pass through input registers controlled
by the rising edge of the clock. The clock input is qualified by
the Clock Enable (CEN) signal, which when deasserted
suspends operation and extends the previous clock cycle.
Maximum access delay from the clock rise is 6.5 ns (133-MHz
device).
• 256K x 18 common IO architecture
• 2.5V/3.3V IO power supply (VDDQ
• Fast clock-to-output times
)
— 6.5 ns (for 133-MHz device)
Write operations are controlled by the two Byte Write Select
(BW[A:B]) and a Write Enable (WE) input. All writes are
conducted with on-chip synchronous self timed write circuitry.
• Clock Enable (CEN) pin to suspend operation
• Synchronous self timed writes
• Asynchronous Output Enable
Three synchronous Chip Enables (CE1, CE2, CE3) and an
asynchronous Output Enable (OE) provide for easy bank
selection and output tri-state control. To avoid bus contention,
the output drivers are synchronously tri-stated during the data
portion of a write sequence.
• Available in Pb-free 100-Pin TQFP package
• Burst Capability — linear or interleaved burst order
• Low standby power
Logic Block Diagram
ADDRESS
REGISTER
A0, A1, A
A1
A0
A1'
A0'
D1
D0
Q1
Q0
MODE
BURST
LOGIC
CE
ADV/LD
CLK
CEN
C
C
WRITE ADDRESS
REGISTER
O
U
T
P
U
T
D
A
T
S
E
N
S
ADV/LD
A
B
U
F
MEMORY
ARRAY
BW
A
WRITE
DRIVERS
E
WRITE REGISTRY
AND DATA COHERENCY
CONTROL LOGIC
S
T
E
E
R
I
DQs
DQP
DQP
BW
B
A
B
A
M
P
F
E
R
S
S
WE
E
N
G
INPUT
REGISTER
E
OE
READ LOGIC
CE
CE
CE
1
2
3
SLEEP
CONTROL
ZZ
Note:
1.For best-practices recommendations, please refer to the Cypress application note System Design Guidelines on www.cypress.com.
Cypress Semiconductor Corporation
Document #: 38-05515 Rev. *E
•
198 Champion Court
•
San Jose, CA 95134-1709
•
408-943-2600
Revised July 09, 2007