Stepping Motor Driver series
High Voltage Series
Stepping Motor Drivers
BD6422EFV (PARALLEL-IN type)
BD6425, BD6423EFV (CLK-IN type)
No.12009EAT06
●Description
These products are a low power consumption PWM constant current-drive driver of bipolar stepping motor with power
supply’s rated voltage of 45V and rated output current of 1.0A, 1.5A.
●Feature
1) Power supply: one system drive (rated voltage of 45V)
2) Rated output current: 1.0A, 1.5A
3) Low ON resistance DMOS output
4) CLK-IN drive mode (BD6425/6423EFV)
5) Parallel IN drive mode (BD6422EFV)
6) PWM constant current control (other oscillation)
7) Built-in spike noise blanking function (external noise filter is unnecessary)
8) FULL STEP & HALF STEP (two kinds), applicable to QUARTER STEP
9) Current decay mode switching function (4 kinds of FAST/SLOW DECAY ratio)
10) Normal rotation & reverse rotation switching function (BD6425/6423EFV)
11) Power save function
12) Built-in logic input pull-down resistor
13) Power-on reset function(BD6425/6423EFV)
14) Thermal shutdown circuit (TSD)
15) Over current protection circuit (OCP)
16) Under voltage lock out circuit (UVLO)
17) Malfunction prevention at the time of no applied power supply (Ghost Supply Prevention)
18) Electrostatic discharge: 8kV (HBM specification)
19) Microminiature, ultra-thin and high heat-radiation (exposed metal type) HTSSOP package
●Application
serial dot impact printer、sewing machine etc.
●Absolute maximum ratings(Ta=25℃)
Item
Supply voltage
Symbol
VCC1,2
BD6425EFV
BD6423/6422EFV
Unit
-0.2~+45.0
-0.2~+45.0
V
1
3
1.45※
4.70※
1.1※
4.0※
W
Power dissipation
Pd
2
4
W
Input voltage for control pin
RNF maximum voltage
VIN
VRNF
IOUT
Topr
-0.2~+5.5
-0.2~+5.5
V
0.7
1.5※
0.7
1.0※
V
A/phase
℃
5
5
Maximum output current
Operating temperature range
Storage temperature range
Junction temperature
-25~+85
-55~+150
+150
-25~+85
-55~+150
+150
Tstg
℃
Tjmax
℃
※1 70mm×70mm×1.6mm glass epoxy board. Derating in done at 11.6mW/℃ for operating above Ta=25℃.
※2 4-layer recommended board. Derating in done at 37.6mW/℃ for operating above Ta=25℃.
※3 70mm×70mm×1.6mm glass epoxy board. Derating in done at 8.8mW/℃ for operating above Ta=25℃.
※4 4-layer recommended board. Derating in done at 32.0mW/℃ for operating above Ta=25℃.
※5 Do not, however exceed Pd, ASO and Tjmax=150℃.
www.rohm.com
© 2012 ROHM Co., Ltd. All rights reserved.
2012.02 - Rev.A
1/8