160 dB Range 100 pA to 10 mA
Low Cost Logarithmic Converter
Data Sheet
ADL5303
FEATURES
SIMPLIFIED BLOCK DIAGRAM
VPS2
10
PWDN
16
VPS1
12
Optimized for fiber optic photodiode interfacing
8 full decades of range
ADL5303
VREF
Law conformance: 0.1 dB from 1 nA to 1 mA
Single-supply operation: 3.0 V to 5.5 V
Complete and temperature stable
PDB
BIAS
VREF
6
8
VPDB
5
2
3
~10kΩ
0.5V
VSUM
INPT
VLOG
BFIN
Accurate laser trimmed scaling
I
PD
TEMPERATURE
COMPENSATION
Logarithmic slope of 10 mV/dB (at the VLOG pin)
Basic logarithmic intercept at 100 pA
Easy adjustment of slope and intercept
Output bandwidth of 10 MHz, 15 V/μs slew rate
Miniature 16-lead package (LFCSP)
9
5kΩ
VSUM
4
BFNG
13
Low power: ~4.5 mA quiescent current (enabled)
15
7
14
11
GND
ACOM
GND
VOUT
APPLICATIONS
Figure 1.
High accuracy optical power measurement
Wide range baseband log compression
Versatile detector for APC loops
GENERAL DESCRIPTION
The ADL5303 is a monolithic logarithmic detector optimized
for the measurement of low frequency signal power in fiber
optic systems and offers a large dynamic range in a versatile and
easily used form. Wide measurement range and accuracy are
achieved using proprietary design and precise laser trimming.
The ADL5303 requires only a single positive supply, VPS, of 5 V.
When using low supply voltages, the log slope can be altered to
fit the available span. Low quiescent current and chip disable
facilitate use in battery-operated applications.
input pin INPT is flanked by the VSUM guard pins that track
the voltage at the summing node. Connecting the exposed pad
of the device to the VSUM pins provides a continuous guard to
minimize leakage into the INPT pin.
The default value of the logarithmic slope at the VLOG output
is set by an internal 5 kΩ resistor. Logarithmic slope can be
lowered with an external shunt resistor or increased using the
buffer and a pair of external feedback resistors. The addition of
a capacitor at the VLOG pin provides a simple low-pass filter.
The intermediate voltage, VLOG, is buffered in an output stage
that can swing to within about 100 mV of ground and the posi-
tive supply, VPS, and provides a peak current drive capacity of
20 mA. An on-board 2 V reference is provided to facilitate
the repositioning of the intercept. The incremental bandwidth
of a translinear logarithmic amplifier inherently diminishes
for small input currents. At IPD =1 nA, the bandwidth of the
ADL5303 is approximately 2 kHz increasing in proportion to
The input current, IPD, flows in the collector of an optimally
scaled NPN transistor, connected in a feedback path around a
low offset JFET amplifier. The current summing input node
operates at a constant voltage, independent of current, with
a default value of 0.5 V; this may be adjusted over a wide range.
An adaptive biasing scheme is provided for reducing photo-
diode dark current at very low light input levels. The VPDB pin
applies approximately 0.1 V reverse bias across the photodiode
for IPD = 100 pA, rising linearly to 2.0 V of reverse bias at IPD
10 mA to improve response time at higher power levels. The
=
IPD up to a maximum value of 10 MHz.
Rev. 0
Document Feedback
Information furnished by Analog Devices is believed to be accurate and reliable. However, no
responsibility is assumed by Analog Devices for its use, nor for any infringements of patents or other
rights of third parties that may result from its use. Specifications subject to change without notice. No
license is granted by implication or otherwise under any patent or patent rights of Analog Devices.
Trademarks and registeredtrademarks arethe property of their respective owners.
One Technology Way, P.O. Box 9106, Norwood, MA 02062-9106, U.S.A.
Tel: 781.329.4700
Technical Support
©2013 Analog Devices, Inc. All rights reserved.
www.analog.com
5秒后页面跳转
摩尔斯微电子在美国约书亚树国家公园测试 Wi-Fi HaLow
贸泽上架Tallysman TW5386智能GNSS天线
SL74HC10N：高性能三输入与非门解析
AIC1781A 电池充电控制器深度解析
微信公众号
抖音公众号
浙公网安备 33010502006866号 浙ICP备10014259号-119
营业执照ICP证
数据手册
如果您发现信息不准确，
