5秒后页面跳转
ADL5306ACPZ-REEL7 PDF预览

ADL5306ACPZ-REEL7

更新时间: 2024-09-17 14:47:39
品牌 Logo 应用领域
亚德诺 - ADI /
页数 文件大小 规格书
16页 726K
描述
60 dB-RANGE (100 nA-100 µA) Low-Cost Logarithmic Converter

ADL5306ACPZ-REEL7 数据手册

 浏览型号ADL5306ACPZ-REEL7的Datasheet PDF文件第2页浏览型号ADL5306ACPZ-REEL7的Datasheet PDF文件第3页浏览型号ADL5306ACPZ-REEL7的Datasheet PDF文件第4页浏览型号ADL5306ACPZ-REEL7的Datasheet PDF文件第5页浏览型号ADL5306ACPZ-REEL7的Datasheet PDF文件第6页浏览型号ADL5306ACPZ-REEL7的Datasheet PDF文件第7页 
60 dB Range (100 nA to 100 µA)  
Low Cost Logarithmic Converter  
ADL5306  
FEATURES  
Optimized for fiber optic photodiode interfacing  
FUNCTIONAL BLOCK DIAGRAM  
VPOS +5V  
NC  
Measures current over 3 decades  
I
PD  
0.2 log  
10  
(
)
VOUT  
Law conformance 0.1 dB from 100 nA to 100 μA  
Single- or dual-supply operation (3 V to 5.5 V total)  
Full log-ratio capabilities  
VREF  
1nA  
BIAS  
2.5V  
GENERATOR  
80k  
R
20kΩ  
COMM  
REF  
200kΩ  
Temperature stable  
0.5V  
Nominal slope of 10 mV/dB (200 mV/decade)  
Nominal intercept of 1 nA (set by external resistor)  
Optional adjustment of slope and intercept  
Rapid response time for a given current level  
Miniature 16-lead chip scale package (LFCSP 3 mm × 3 mm)  
Low power: ~5 mA quiescent current  
SCAL  
BFIN  
IREF  
V
14.2kΩ  
BIAS  
V
BE2  
1kΩ  
Q2  
Q1  
I
LOG  
TEMPERATURE  
COMPENSATION  
1nF  
VLOG  
451Ω  
V
BE1  
I
PD INPT  
VSUM  
1nF  
6.69kΩ  
COMM  
APPLICATIONS  
1kΩ  
Low cost optical power measurement  
Wide range baseband logarithmic compression  
Measurement of current and voltage ratios  
Optical absorbance measurement  
0.5V  
1nF  
VNEG  
COMM  
03727-0-001  
Figure 1. Functional Block Diagram  
The logarithmic intercept (reference current) is nominally  
GENERAL DESCRIPTION  
positioned at 1 nA by using the externally generated, 100 µA IREF  
current provided by a 200 kΩ resistor connected between VREF, at  
2.5 V, and IREF, at 0.5 V. The intercept can be adjusted over a  
narrow range by varying this resistor. The part can also operate in a  
log-ratio mode, with limited accuracy, where the numerator and  
denominator currents are applied to INPT and IREF, respectively.  
The ADL5306is a low cost microminiature logarithmic converter  
optimized for determining optical power in fiber optic systems. The  
ADL5306 is derived from the AD8304 and AD8305 translinear  
logarithmic converters. This family of devices provides wide  
measurement dynamic range in a versatile and easy-to-use form. A  
single-supply voltage between 3 V and 5.5 V is adequate; dual  
supplies may optionally be used. Low quiescent current (5 mA  
typical) permits use in battery-operated applications.  
A buffer amplifier is provided to drive substantial loads, raise the  
basic 10 mV/dB slope, serve as a precision comparator (threshold  
detector), or implement low-pass filters. Its rail-to-rail output stage  
can swing to within 100 mV of the positive and negative supply  
rails, and its peak current-sourcing capacity is 25 mA.  
IPD, the 100 nA to 100 µA input current applied to the INPT pin, is  
the collector current of an optimally scaled NPN transistor that  
converts this current to a voltage (VBE) with a precise logarithmic  
relationship. A second converter is used to handle the reference  
current, IREF, applied to IREF. These input nodes are biased slightly  
above ground (0.5 V). This is generally acceptable for photodiode  
applications where the anode does not need to be grounded.  
Similarly, this bias voltage is easily accounted for in generating IREF  
The logarithmic front end’s output is available at VLOG.  
A fundamental aspect of translinear logarithmic converters is that  
small-signal bandwidth falls as current level diminishes, and low  
frequency noise-spectral density increases. At the 100 nA level, the  
ADL5306s bandwidth is about 100 kHz; it increases in proportion  
to IPD up to a maximum of about 10 MHz. The increase in noise  
level at low currents can be addressed by using a buffer amplifier to  
realize low-pass filters of up to three poles.  
.
The basic logarithmic slope at this output is 200 mV/decade  
(10 mV/dB) nominal; a 60 dB range corresponds to a 600 mV  
output change. When this voltage (or the buffer output) is applied  
to an ADC that permits an external reference voltage to be  
employed, the ADL5306s 2.5 V voltage reference output at VREF  
can be used to improve scaling accuracy.  
The ADL5306 is available in a 16-lead LFCSP package and is  
specified for operation from–40°C to +85°C.  
Protected by US Patent 5,519,308.  
Rev. 0  
Information furnished by Analog Devices is believed to be accurate and reliable.  
However, no responsibility is assumed by Analog Devices for its use, nor for any  
infringements of patents or other rights of third parties that may result from its use.  
Specifications subject to change without notice. No license is granted by implication  
or otherwise under any patent or patent rights of Analog Devices. Trademarks and  
registered trademarks are the property of their respective companies.  
One Technology Way, P.O. Box 9106, Norwood, MA 02062-9106, U.S.A.  
Tel: 781.329.4700  
Fax: 781.326.8703  
www.analog.com  
© 2003 Analog Devices, Inc. All rights reserved.  

ADL5306ACPZ-REEL7 替代型号

型号 品牌 替代类型 描述 数据表
ADL5306ACP-REEL7 ADI

完全替代

60 dB Range (100 nA to 100 UA) Low Cost Logarithmic Converter
SN74ALS29827NT TI

功能相似

10-BIT BUFFERS AND BUS DRIVERS WITH 3-STATE OUTPUTS

与ADL5306ACPZ-REEL7相关器件

型号 品牌 获取价格 描述 数据表
ADL5308 ADI

获取价格

快速响应188 dB范围(10 pA至25 mA)对数转换器
ADL5310 ADI

获取价格

120 dB Range (3 nA to 3 mA) Dual Logarithmic Converter
ADL5310_18 ADI

获取价格

Dual Logarithmic Converter
ADL5310ACP ADI

获取价格

暂无描述
ADL5310ACP-R2 ADI

获取价格

120 dB Range (3 nA to 3 mA) Dual Logarithmic Converter
ADL5310ACP-REEL7 ADI

获取价格

120 dB Range (3 nA to 3 mA) Dual Logarithmic Converter
ADL5310ACP-WP ADI

获取价格

暂无描述
ADL5310ACPZ ADI

获取价格

暂无描述
ADL5310ACPZ-REEL7 ADI

获取价格

120 dB Range (3 nA to 3 mA) Dual Logarithmic Converter
ADL5310-EVAL ADI

获取价格

120 dB Range (3 nA to 3 mA) Dual Logarithmic Converter